Interface Commands - ZyXEL Communications XS3800-28 Cli Reference Manual

Use these commands to configure basic port settings.
37.1 Command Summary
The following section lists the commands for this feature.
Table 96 interface Command Summary
COMMAND
clear interface <port-num>
interface port-channel <port-list>
bpdu-control
<peer|tunnel|discard|network>
cx4-length <0.5|1|3|5|10|15>
flow-control
frame-type
<all|tagged|untagged>
inactive
intrusion-lock

Interface Commands

Ethernet Switch CLI Reference Guide
C
H A P T E R
DESCRIPTION
Clears all statistics for the specified port.
Enters config-interface mode for the specified port(s).
Sets how Bridge Protocol Data Units (BPDUs) are used
in STP port states.
peer: process any BPDU (Bridge Protocol Data Units)
received on this port.
tunnel: forward BPDUs received on this port.
discard: drop any BPDU received on this port.
network: process a BPDU with no VLAN tag and
forward a tagged BPDU.
Sets the number of meters for the length of the
10GBASE-CX4 cable you use to connect between the
Switch and another switch for stacking.
Enables interface flow control. Flow control regulates
transmissions to match the bandwidth of the receiving
port.
Choose to accept both tagged and untagged
incoming frames (all), just tagged incoming frames
(tagged) or just untagged incoming frames on a port
(untagged).
Note: Not all switch models support accepting
untagged frames on a port.
Disables the specified port(s) on the Switch.
Enables intrusion lock on the port(s) and a port cannot
be connected again after you disconnected the
cable.
Note: Intrusion lock is not available on a 10
Gigabit Ethernet port.
135
37
M P
E 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13