Vlan Ip Commands - ZyXEL Communications XS3800-28 Cli Reference Manual

Use these commands to configure the default gateway device and add IP domains for VLAN.
97.1 IP Interfaces Overview
The Switch needs an IP address for it to be managed over the network. The factory default IP address is
192.168.1.1. The subnet mask specifies the network number portion of an IP address. The factory default
subnet mask is 255.255.255.0.
97.2 Command Summary
The following section lists the commands for this feature.
Table 222 vlan ip address Command Summary
COMMAND
show vlan <vlan-id>
vlan <1-4094>
ip address default-
management dhcp-bootp
no ip address default-
management dhcp-bootp
ip address default-management
dhcp-bootp option-60
no ip address default-
management dhcp-bootp option-
60
ip address default-management
dhcp-bootp option-60 class-id
<class-id>
no ip address default-
management dhcp-bootp option-
60 class-id
ip address default-
management <ip-address>
<mask>
ip address default-
management dhcp-bootp
release

VLAN IP Commands

DESCRIPTION
Displays the status of the specified VLAN.
Enters config-vlan mode for the specified VLAN. Creates
the VLAN, if necessary.
Configures the Switch to get the in-band management IP
address from a DHCP server.
Configures the Switch to use the static in-band
management IP address. The Switch uses the default IP
address of 192.168.1.1 if you do not configure a static IP
address.
Enables DHCP option 60. When you enable DHCP option
60, make sure you set up a Vendor Class Identifier.
Disables DHCP option 60.
Defines a Vendor Class Identifier for DHCP option 60.
Reset the Vendor Class Identifier for DHCP option 60 to
default settings.
Sets and enables the in-band management IP address
and subnet mask.
Releases the in-band management IP address provided
by a DHCP server.
Ethernet Switch CLI Reference Guide
345
C
H A P T E R
97
M P
E 3
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13