ZyXEL Communications XS3800-28 Cli Reference Manual page 365

Table 232 Command Summary: Additional Enable Mode (continued)
COMMAND
show version [flash]
telnet ipv4_address
test interface port-channel
<port-list>
write memory [<index>]
Table 233 Command Summary: Additional Configure Mode
COMMAND
bcp-transparency
default-management <in-
band|out-of-band>
except-smac zero-smac-drop
hostname <name>
install help
install slot <slot-list>
type <card-type>
locator-led
locator-led <1-1440>
mode zynos
no except-smac zero-smac-
drop
no install slot <slot>
no locator-led
no shutdown slot <slot-list>
shutdown slot <slot-list>
transceiver-ddm timer <1 -
4294967>
Chapter 106 Additional Commands
DESCRIPTION
Display the version of the currently running firmware on the
Switch. Optionally, display the version of the currently installed
firmware on the flash memory.
Connects to a specified host using Telnet.
Performs an internal loopback test on the specified ports. The
test returns Passed! or Failed!.
Saves current configuration in volatile memory to the
configuration file the Switch is currently using or the specified
configuration file.
DESCRIPTION
Enables Bridge Control Protocol (BCP) transparency on the
Switch.
Sets which traffic flow (in-band or out-of-band) the Switch
sends packets originating from itself (such as SNMP traps) or
packets with unknown source.
Sets the Switch to filter and drop the packets with an all-zero
source MAC address (00:00:00:00:00:00).
Sets the Switch's name for identification purposes.
name: 1-64 printable characters; spaces are allowed if you put
the string in double quotation marks (").
Displays command help information.
Changes what type of card is in the slot without restarting the
system.
Turns on the LOCATOR LED on the Switch. By default, the LED
blinks and automatically turns off after 30 minutes.
This helps to locate the Switch that you are managing when
multiple switches are installed in a rack or placed in the same
room.
Changes how long (in minutes) the LOCATOR LED blinks for.
Changes the CLI mode to the ZyNOS format.
Sets the Switch to allow and forward the packets with an all-
zero source MAC address (00:00:00:00:00:00).
Uninstalls the card in the slot.
Stops the LOCATOR LED from blinking immediately.
Turns on the power to the slot.
Turns off the power to the slot.
Sets the duration of the digital diagnostic monitoring (DDM)
timer.
This defines how often (in milliseconds) the Switch sends the
digital diagnostic monitoring (DDM) information via the
installed transceiver(s).
Ethernet Switch CLI Reference Guide
365
M P
E 0
E 13
E 13
E 13
M P
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13