Mac-Based Vlan - ZyXEL Communications XS3800-28 Cli Reference Manual

Use these commands to bind a client source MAC address to a VLAN on the Switch.
51.1 MAC-based VLAN Overview
The MAC-based VLAN feature assigns incoming untagged packets to a VLAN and classifies the traffic
based on the source MAC address of the packet. When untagged packets arrive at the switch, the
source MAC address of the packet is looked up in a MAC to VLAN mapping table.
If an entry is found, the corresponding VLAN ID is assigned to the packet. The assigned VLAN ID is verified
against the VLAN table. If the VLAN is valid, ingress processing on the packet continues; otherwise, the
packet is dropped.
This feature allows users to change ports without having to reconfigure the VLAN, which allows better
mobility. You can assign priority to the MAC-based VLAN and define a MAC to VLAN mapping table by
entering a specified source MAC address in the MAC-based VLAN using a command. You can also
delete a MAC-based VLAN entry using a command described below.
51.2 Command Summary
The following section lists the commands for this feature.
Table 140 MAC-based VLAN Command Summary
COMMAND
mac-based-vlan name <name>
source-mac <mac-addr> vlan
<vlan-id> priority <0-7>
no mac-based-vlan source-mac
<mac-addr>
show mac-based-vlan

MAC-based VLAN

DESCRIPTION
Adds a binding client source MAC address to a VLAN and
sets priority level.
Name: 1-32 alphanumeric characters
Removes a binding client source MAC address to a VLAN.
Show status of the MAC-based VLAN.
Ethernet Switch CLI Reference Guide
201
C
H A P T E R
51
M P
C 13
C 13
E 13