ZyXEL Communications XS3800-28 Cli Reference Manual page 244

63.2 Command Examples
This example enables Power over Ethernet (PoE) on ports 1-4 and enables traps when the power usage
reaches 25%.
sysname# configure
sysname(config)# pwr interface 1-4
sysname(config)# pwr usagethreshold 25
sysname(config)# pwr mibtrap
sysname(config)# exit
This example sets the maximum amount of power allowed for port 2 to 7500 mW.
sysname# configure
sysname(config)# pwr interface 2 max-power 7500
sysname(config)# exit
This example creates a schedule (named Work), applies the pre-defined schedule to port 1 and displays
the port's current PoE state.
sysname# configure
sysname(config)# time-range Work periodic weekdays 08:00 to 20:00
sysname(config)# pwr interface 1 time-range Work
sysname(config)# exit
sysname# show pwr time-range interface
sysname# show pwr time-range interface 1
Port TimeRange
---- ---------
1
sysname# exit
This example enables auto PD discovery on the Switch and ports 1 to 3.
sysname# configure
sysname(config)# pwr auto-pd-recovery
sysname(config)# pwr interface 1-3 auto-pd-recovery
sysname# exit
Chapter 63 PoE Commands
State
-----
Work Out
Ethernet Switch CLI Reference Guide
244