ZyXEL Communications XS3800-28 Cli Reference Manual page 245

This example shows the current status and configuration of Power over Ethernet.
sysname# sh pwr
PoE Mode : Classification mode
Continuous PoE : enable
Total Power:60.0(W)
Usage:10(%)
Consuming Power:6.9(W)
Allocated Power:30.0 (W)
Remaining Power:30.0(W)
Averaged Junction Temperature: 42 (c), 107 (f).
Port State PD
xPower(mW)
---- ------ ---
----------
1 Enable On
30000
2 Enable Off
0
3 Enable Off
0
4 Enable Off
0
5 Enable Off
0
The following table describes the labels in this screen.
Table 161 show pwr
LABEL
PoE Mode
Continuous PoE
Total Power
Usage
Consuming Power
Allocated Power
Remaining Power
Averaged Junction
Temperature
Port
State
Chapter 63 PoE Commands
Class Priority Power-Up
----- -------- --------
4 Low 802.3bt
0 Low 802.3bt
0 Low 802.3at
0 Low 802.3at
0 Low 802.3at
DESCRIPTION
This field displays the power management mode used by the Switch, whether it is in
Classification or Consumption mode.
This field displays whether continuous PoE is enabled on the Switch.
This field displays the total power the Switch can provide to PoE-enabled devices.
This field displays the percentage of PoE Power consumption.
This field displays the amount of power the Switch is currently supplying to the PoE-
enabled devices.
This field displays the total amount of power the Switch has reserved for PoE after
negotiating with the PoE device(s).
Note: If the management mode is set to Consumption, this field shows NA.
This field displays the amount of power the Switch can still provide for PoE.
Note: The Switch must have at least 16 W of remaining power in order to
supply power to a PoE device, even if the PoE device requested less
than 16 W.
This field displays the internal temperature of the PoE chipset.
This field displays the port number.
This field indicates whether or not PoE is enabled on this port.
Ethernet Switch CLI Reference Guide
245
Wide Range Consumption (mW)
---------- ----------------
Enable
Enable
Enable
Enable
Enable
Ma
--
6900
0
0
0
0