ZyXEL Communications XS3800-28 Cli Reference Manual page 236

This example configures an OSPF interface for the 172.16.1.1/24 network and specifies to use simple
authentication with the key 1234abcd. The priority for the Switch is also set to 1, as this router should
participate in router elections.
interface route-domain 172.16.1.1/24
sysname(config)#
(config-if)# ip ospf authentication-key abcd1234
sysname
(config-if)# ip ospf priority 1
sysname
sysname# show ip ospf interface
swif2 is up, line protocol is up
Internet Address 172.16.1.1/24, Area 0.0.0.0
Router ID 172.16.1.1, Network Type BROADCAST, Cost: 15
Transmit Delay is 1 sec, State Waiting, Priority 1
No designated router on this network
No backup designated router on this network
Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
Hello due in 00:00:04
Neighbor Count is 0, Adjacent neighbor count is 0
In this example, the Switch (Z) is a redistributor between a RIP network and an OSPF network. It
summarizes 4 routing entries 192.168.8.0/24 ~ 192.168.11.0/24 (learned from RIP router A) into 192.168.8.0/
22 and then sends it to OSPF router B.
Figure 10 OSPF Redistribution Summary Address Example
RIP
A
192.168.8.0/24
192.168.9.0/24
192.168.10.0/24
192.168.11.0/24
Chapter 61 OSPF Commands
IP: 172.16.1.1
Z
Redistributor
Ethernet Switch CLI Reference Guide
236
OSPF
B
192.168.8.0/22