ZyXEL Communications XS3800-28 Cli Reference Manual page 271

71.3 Command Examples: Port by Port Configuration
This example configures WFQ on ports 1-5 and assigns weight values (1,2,3,4,12,13,14,15) to the physical
queues (Q0 to Q8).
sysname(config)# interface port-channel 1-5
sysname(config-interface)# wfq
sysname(config-interface)# weight 1 2 3 4 12 13 14 15
71.4 Command Summary: System-Wide Configuration
The following section lists the commands for this feature.
Table 171 Queueing Command Summary
COMMAND
queue priority <0-7> level <0-7>
spq
wrr
wfq
fe-spq <q0|q1| ... |q7>
71.5 Command Examples: System-Wide
This example configures WFQ on the Switch and assigns weight values (1,2,3,4,12,13,14,15) to the
physical queues (Q0 to Q8).
sysname(config)# wfq
sysname(config)# interface port-channel 1-5
sysname(config-interface)# weight 1 2 3 4 12 13 14 15
Chapter 71 Queuing Commands
DESCRIPTION
Sets the IEEE 802.1p priority level-to-physical queue
mapping.
priority <0-7>: IEEE 802.1p defines up to eight separate
traffic types by inserting a tag into a MAC-layer frame that
contains bits to define class of service. Frames without an
explicit priority tag are given the default priority of the
ingress port.
level <0-7>: The Switch has up to 7 physical queues that
you can map to the 8 priority levels. On the Switch, traffic
assigned to higher index queues gets through faster while
traffic in lower index queues is dropped if the network is
congested.
Note: Some models only support 4 queues.
Sets the Switch to use Strictly Priority Queuing (SPQ).
Sets the Switch to use Weighted Round Robin (WRR).
Sets the Switch to use Weighted Fair Queuing (WFQ).
Enables SPQ starting with the specified queue and
subsequent higher queues on the 10/100 Mbps ports.
Ethernet Switch CLI Reference Guide
271
M P
C 13
C 13
C 13
C 13
C 13