Paper Alignment At The Registration Roller - Toshiba e-studio200l Service Handbook

3.2.2

Paper alignment at the registration roller

The aligning amount is adjusted by using the following codes in Adjustment Mode (05).
Paper
Weight
type
Plain
2
64-80 g/m
paper
17-20 lb.
Thick 2
81-105g/m
paper 1
21-28 lb.
Thick
2
106-163g/m
paper 2
29-43 lb.
Thick 2
164-209g/m
paper 3
44-55 lb.
OHP -
Sub-code
(*1) 0: Long size 1: Middle size 2: Short size
(*2) 0: Long size 1: Middle size 2: Short size 3: Post card
(*3) 0: Long size of OHP film 1: Middle size of OHP film 2: Short size of OHP film
Notes:
1. Long size: 330 mm or longer (13.0 inches or longer)
Middle size: 220-239 mm (8.7-12.9 inches)
Short size: 219 mm or shorter (8.6 inches or shorter)
2. The adjustment of "Post card" is for Japan only.
<Procedure>
(1) Perform the test print according to the following procedure.
[0][5]
(Code) [START]
[Power]
[SET] or
[INTERRUPT]
Stores in memory
(*4) 1: Single-sided grid pattern 3: Double-sided grid pattern
© 2004 - 2010 TOSHIBA TEC CORPORATION All rights reserved
Upper Lower PFP upper
drawer drawer drawer
450 (*1) 452 (*1) 448 (*1)
469 (*1) 470 (*1) 471 (*1)
- -
- -
- -
(Not necessary for LCF)
(Sub-code)
[Drawer
selection]
3 - 5
PFP lower
LCF
drawer
449 (*1) 457
472 (*1) 473
- -
- -
- -
Current value
[START]
displayed
(*4) +[FAX]
(Test print)
e-STUDIO200L/202L/203L/230/230L/232/233/280/282/283
Bypass
ADU
feed
455 (*1) 458 (*1)
474 (*1) 460 (*1)
- - 461 (*1)
- - 462 (*2)
- - 463 (*3)
Enter new
value
[POWER]
OFF/ON
(Exit)
ADJUSTMENT
3