Paper Alignment At The Registration Roller - Toshiba e-STUDIO2006 Service Manual

6.3.3

Paper alignment at the registration roller

The aligning amount is adjusted by using the following codes in Adjustment Mode (05).
Paper type Weight
Plain paper
64 - 80 g/m
17 - 20 lb. Bond
Thick paper 1
81 - 105g/m
21 - 28 lb. Bond
Thick paper 2
106 - 163g/m
29 lb. Bond -
90 lb. Index
Thin paper
52 - 63 g/m
OHP -
Envelope -
Sub-code
(*1) 0: Long size 1: Middle size 2: Short size
(*2) 0: Long size 1: Middle size 2: Short size 3: Post card
(*3) 0: Long size of OHP film 1: Middle size of OHP film 2: Short size of OHP film
(*4) 0: Long size of Envelope 1: Middle size of Envelope 2: Short size of Envelope
Notes:
1. Long size: 330 mm or longer (13.0 inches or longer)
Middle size: 220-239 mm (8.7-12.9 inches)
Short size: 219 mm or shorter (8.6 inches or shorter)
<Procedure>
(1) Perform the test print according to the following procedure.
[0][5]
(Code)
[Power]
Enter new
value
(Select the paper source)
(*5) 1: Single-sided grid pattern
e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
SETTING / ADJUSTMENT
1st Bypass
drawer feed
4100 (*1) 4103 (*1)
2
2 - 4104 (*1)
- 4105 (*1)
2
2 - 4102 (*2)
- 4107 (*3)
- 4405 (*4)
[START] (Sub Code)
[OK]
(Stored in memory)
[STRAT]
2nd
ADU drawer
(PFU)
4110 (*1) 4101 (*1)
4120 (*1) -
- -
- -
- -
- -
[START]
[1] (*5) [SETTINGS]
(Test print)
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
6 - 6
PFP
PFP lower
upper
drawer
drawer
<20H/23H/
<20H/23H/
25H, 23HA/
25H, 23HA/
28HA>
28HA>
4108 (*1) 4109 (*1)
- -
- -
- -
- -
- -
Current value
displayed