Paper Alignment At The Registration Roller - Toshiba e-STUDIO281c Service Handbook

3.4.2

Paper alignment at the registration roller

The aligning amount is adjusted by using the following codes in Adjustment Mode (05).
Paper type Weight
Plain paper 64-80 g/m
2
17-20 lb.
Thick
81-105 g/m
paper 1
21-28 lb.
Thick
106-163 g/m
paper 2
29-43 lb.
Thick
164-209 g/m
paper 3
44-55 lb.
OHP film -
Sub-code
(*1) 0: Long size
(*2) 0: Long size
(*3) 0: Long size of thick paper 2
2: Short size of thick paper 2
4: Middle size of thick paper 3
6: Long size of OHP film
8: Short size of OHP film
(*4) 0: Long size
Notes:
1. Long size: 330 mm or longer (13.0 inches or longer)
Middle size: 220-329 mm (8.7-12.9 inches)
Short size: 219 mm or shorter (8.6 inches or shorter)
Short size 1: 205-219 mm (8.1-8.6 inches or shorter)
Short size 2: 204 mm or shorter (8.0 inches or shorter)
2. The adjustment of "Post card" is for Japan only.
<Procedure>
[ 0 ][ 5 ]
( Code )
[ Power ]
[ INTERRUPT ]
Stores in memory
(*5) 1: Single-sided grid pattern in Black Mode
3: Double-sided grid pattern in Black Mode
55: Grid pattern of thick paper 2 in Full Color Mode
56: Grid pattern of thick paper 3 in Full Color Mode
57: Grid pattern of OHP film in Full Color Mode
58: Single-sided grid pattern of thick paper 2 in Black Mode
59: Single-sided grid pattern of thick paper 3 in Black Mode
60: Single-sided grid pattern of OHP film in Black Mode
Note: Note:
If the aligning amount is too large, abnormal noise (paper-folding noise) or actual paper folding
may occur during paper feeding. If the aligning amount is too small, on the other hand, a skew,
an image dislocation in feeding direction or a paper exit jam (E010) may occur. Pay attention to
the above and select the appropriate value.
e-STUDIO281c/351c/451c
ADJUSTMENT
Upper Lower
drawer drawer
450 (*4) 452 (*4)
469 (*4) 470 (*4)
2
2 - -
- -
2
- -
1: Middle size
1: Middle size
1: Middle size
( Not necessary for LCF )
[ START ] ( Sub-code )
[ SET ] or
PFP PFP
upper lower
drawer drawer
448 (*4) 449 (*4)
471 (*4) 472 (*4)
- -
- -
- -
2: Short size
2: Short size 3: Post card
1: Middle size of thick paper 2
3: Long size of thick paper 3
5: Short size of thick paper 3
7: Middle size of OHP film
9: Post card
2: Short size 1 3: Short size 2
Current value
[ START ]
displayed
[ Drawer
( *5 ) + [ FAX ]
selection ]
( Test print )
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
3 - 8
Bypass feed
LCF ADU
Black Color
457 455 (*1) 458 (*1)
473 474 (*1) 460 (*1)
- - 461
(*1)
- - 462
(*2)
- - 463
(*1)
Enter new
value
[ POWER ]
OFF/ON
475
(*3)
475
(*3)
475
(*3)
( Exit )