Cadillac 60 Series 1963 Shop Manual page 581

16-112
BODY
SOLENOID IDENTIFICATION
1. REAR VERTICAL SOLENOID
2. HORIZONTAL SOLENOID
3. FRONT VERTICAL SOLENOID
CIRCUIT BREAKER
CONNECTOR
BENEATH SEAT
:
—I
I
I
G
TRANSMISSION & CLUTCH
CONTROL SOLENOIDS
RELAY
SEAT ADJUSTER
MOTOR
ARMATURE FEED - RED
FIELD FEEDS
YELLOW
S I X - W A Y SEAT SWITCH TERMINAL BLOCK
IN ARM REST
No.
1
2
3
4
5
6
COLOR
RED
DARK BLUE
PINK
DARK GREEN
WHITE
YELLOW
FUNCTION
FEED
SOLENOID -HORIZONTAL MOVEMENT
FIELD F E E D - F O R W A R D & U P W A R D
SOLENOID-REAR EDGE VERTICAL
SOLENOID - FRONT EDGE VERTICAL
FIELD F E E D - R E A R W A R D & D O W N
Fig. 16-139 Six-Way Seat Circuit - Switch In Arm Rest
e. Checking Wires Between Control
Switch and Motor Relay
1. Disengage 3-wire harness connector from
relay at motor.
2. Insert one light tester lead into the motor
field connector slot on harness and ground the
other lead.
3. Actuate seat switch to energize field wire
being tested.
4. If tester does not light, there is no current
at end of wire. Failure is caused by an open or
short circuit between end of wire and switch.
Check other motor field wire in same manner.
f. Checking Relay Assembly
1. Disconnect three motor leads from relay
assembly. These are wires leading from motor
to relay.
2. Connect one end of a jumper wire to one of
the motor field feed studs on relay and ground
other end of jumper wire.
3. Connect one end of light tester to motor
armature feed stud on relay and ground other
light tester lead.
4. With a jumper wire, energize field stud
which is not grounded. If tester does not light,
relay is defective.
g. Checking Motor Assembly
1. Disconnect motor armature feed lead and
one of the motor field feeds from the relay
assembly.