Cadillac 60 Series 1963 Shop Manual page 318

ELECTRICAL SYSTEM
12-37
Split Image Target
Right-Left Dial
Viewing Ports
Down-Up Dial
Vertical Calibration Level
Floor Level Compensator Screw
Fig. 12-60 Calibrating Headlamp Aimer
3. Slide retaining ring and sealed beam assem-
bly off adjusting screws.
4. Disconnect connector plug from sealed beam
unit.
5. Remove two screws and separate backing
plate from sealed beam unit. Remove ring from
sealed beam unit.
b. Installation
1. Position new sealed beam unit in retaining
ring and install ring with unit to backing plate,
securing with two screws.
2. Secure connector plug to back of sealed beam
unit.
3. Position ring with sealed beam assembly
on adjusting screws. Connect retaining spring
to ring.
4. Install headlight door and secure with four
screws.
49. Bulb Replacement (Except
Instrument Panel Cluster)
A complete list of replacement bulbs required
for 1963 cars is given in the Bulb Chart, Page
12-99. The procedures for making bulb replace-
ments are as follows:
a. Front Turn Signal and Parking Lamps
Remove two screws securing lens to housing.
Remove lens and replace bulb.
b. Back-up, Tail, Stop, and Signal Lamp
Assembly (Bumper)
1. Remove two reflex attaching screws and re-
move reflex.