Cadillac 60 Series 1963 Shop Manual page 458

14-9
5. Remove two nuts retaining rear lamp assem-
bly, and remove lamp and escutcheon.
6. Remove four bolts that secure end bar to
center bar.
7. Remove two bolts that secure end bar to
finish panel extension.
8. Remove rubber cushion assembly from upper
bracket on end bar by sliding rubber cushion off
bracket.
9. Separate end impact bar from bumper
assembly.
b. Installation
1. Install rubber cushion assembly on upper
bracket of end bar by sliding over bracket.
2. Position end bar in place on bumper assem-
bly and secure to center bar using four bolts.
3. Install two bolts that secure end bar to finish
panel extension.
4. Position escutcheon in end section, and in-
stall lamp assembly in escutcheon and secure
with two nuts. Route light green wire through hole
in lower bracket and insert green wire into plastic
connector.
5. Route wiring through six plastic straps and
secure straps to center bar.
6. Install reflex lens insert bar and secure
with two screws.
7. Install reflex lens and secure with two
screws.
20. Rear Bumper Center Impact Bar
Removal and Installation
a. Removal
1. Remove rear
scribed in Note 15a.
bumper assembly as de-
2. Disconnect six plastic harness straps from
center impact bar, and remove light green wire
from connector.
3. Remove eight bolts, four on each side, re-
taining finish panels to center impact bar.
4. Remove four screws securing right and left
license guards to center impact bar.
5. Remove eight bolts, four each side, securing
right and left end impact bar to center bar.
6. Remove center impact bar from bumper
assembly.
b. Installation
1. Position center impact bar to end impact
bars and loosely install eight bolts, four each
side.
2. Align center impact bar to end impact bars
and tighten these bolts.
3. Install right and left license guards and
secure to center impact bar with four screws,
two at each license guard.
4. Position right and left finish panels and
secure to center impact bar with eight bolts, four
each side.
5. Connect six plastic harness straps to center
impact bar and install light green wire in
connector.
8. Install rear bumper assembly as described
in Note 15b.
6. Install rear bumper assembly as described
in Note 15b.
TORQUE SPECIFICATIONS
Material
No.
260M
260M
280M
280M
280M
260M
Special
Special
Special
260M
NOTE: Refer
Application
Hood Hinge to Hood
Hood Hinge to Gowl
Front Bumper Mounting Bar to Frame
Rear Bumper Mounting Bar to Frame
Front or Rear Bumper Mounting Bar to Frame
Front Fender to Radiator Cradle
Front Fender to Cowl
Front Fender to Rocker Panel
Front Fender to Pillar
Front Fender to Cowl Tie Rod
to back of manual, Page 17-1 for bolt and nut markings,
Size
3/8-16
3/8-16
9/16-18
1/2-20
1/2-20
3/8-16
3/8-16
3/8-16
3/8-16
5/16-24
and steel
Foot
Pounds
25
30
50
45
45
25
25
25
25
3
classifications.