Cadillac 60 Series 1963 Shop Manual page 416

HEATING AND AIR CONDITIONING
13-35
O-Rings
h Pressure Relief Valve
1 \ Copper Gasket
J k 1 / i°~
.. 7 v_-
1
/ /
Rear Head /
Outer Oil Pump Gear
Rear Discharge Valve Plate
O-Ring. Front Head
/ ( )/M\
/ — ( K o
Ri n g ^ _ ^ * b * 0 |
Suction Screen """•"««. _..
Inner Oil Pump Gear ^ . ^ Drain Plug
\ / Oil Pick-up Tube """-.».
A>[/T"^ \ °/"
Rin9
Rear Sucti o n Reed' / / / ^ ? K J f c r - > *
Bushing^ / / | ^ ^ ^ |
Needle Bearing / 1 ^
O-Ring /
1 \
Rear Cylinder Half
Piston Ring-"''
BalK
Shoe Disc
Shaft Seal Assembly
I Seal Seat
1 / Seal Seat Retainer
f 1 /
Ring
/ / Clutch Coil Retainer Ring
%( /
/Jo
Piston 1
1
Piston Ring
e
Shaft 1
Discharge Crossover Tube
Thrust
Compressor
m /
^ 1 jkJ
Swash Plate
I
/
/ Do
Races
Shell
Clutch Coil and Housing Assembly
.Pulley
/
B
^m^ /
^ ^ ^ /
til /
Suction
earing
Bearing Retainer
/ Pulley Retainer Ring
/ / Clutch Plate and
1 / / Hub Assembly
J 1 Retainer Ring
Qj$mt\ /
L o c k N u t
fR&*?oj
Crossover Cover "~-^ Spacer
"
Gas <et
-Thrust
wel Pins
O-Ring
Bushing
Fror
Suction
Bearing
Front Cylnder Half " 7
Needle Bearing /
«£*€% /
Reed
Front Discharge
Valve Plate Assembly
Fig. 13-28 Compressor Disassembled
from end of shaft, using Thin Wall Socket, J-9399,
Fig. 13-29.
3. Thread Clutch Plate and Hub Assembly Re-
mover, J-9401, into hub. Hold body of tool with
a wrench and tighten center screw to remove
clutch plate and hub assembly, Fig. 13-30.
4. Remove square drive key from shaft.
5. Remove hub retainer ring using Snap Ring
Pliers, J-5403 (#21), and then remove hub spacer,
Fig. 13-31.
b. Installation
1. Install square drive key on shaft, allowing
it to project approximately 3/16 inch out of
key way.
2. Wipe frictional surfaces of clutch plate and
pulley clean.
3. Place clutch plate and hub assembly on
shaft, aligning shaft key with keyway in hub.
CAUTION: To avoid internal damage to
compressor, do not drive or pound on hub or
shaft. This could mis-position swash plate on
shaft, resulting in damage to compressor.
4. Place Spacer, J-9480-2, on hub, Fig. 13-32.
Insert end of Clutch Plate and Hub Assembly In-
staller, J-9480, through spacer and thread tool
on to end of shaft.
Fig. 13-29 Removing Lock Nut From End of Shaft