Cadillac 60 Series 1963 Shop Manual page 528

BODY
16-59
3. Remove screws securing horizontal and ver-
tical cable end plate on both sides of transmission
and detach cables from transmission.
4. Remove transmission to support attaching
bolts; then, disengage transmission from rubber
coupler and remove transmission from seat
assembly.
5. To install, reverse removal procedure.
k. Front Seat Adjuster Transmission
(Four-Way, Tilt)
Disassembly and Assembly
1. Remove front seat adjuster transmission
from seat assembly.
2. Remove screws securing gear and solenoid
housings t o g e t h e r ; then, carefully separate
housings and remove component parts of trans-
mission assembly, Fig. 16-68.
3. To assemble transmission, reverse remov-
al procedure.
IMPORTANT: Prior to or during installa-
tion, lubricate frictional surfaces of driving
gear thrust washer, gears, dog washers, shaft
and solenoid plungers.
I. Torque Tube Assembly (Four-Way, Tilt)
Removal and Installation
1. Remove front seat assembly from body and
place upside down on a clean protected surface.
2. Remove adjuster to seat bottom frame front
and rear attaching bolts.
3. Remove nuts securing motor and transmis-
sion support to inboard adjuster, Fig. 16-65,
4. Carefully disengage adjuster from support
and torque tube assembly; then, remove adjuster
from seat.
5. Disengage torque tube from opposite adjuster
and remove tube from seat assembly.
6. To install, reverse removal procedure.
Check seat adjuster for proper operation.
m. Motor and Transmission Support
(Four-Way, Tilt)
Removal and Installation
1. Remove front seat assembly from body and
place upside down on a clean protected surface.
2. Remove nuts securing support to both ad-
justers. See Fig. 16-64 for outboard adjuster
and Fig. 16-65 for inboard adjuster.
3. Carefully remove support from adjusters
with attached motor, transmission and relay
assembly.
4. If replacing support, transfer motor, trans-
mission and relay assembly to new part.
5. To install, reverse removal procedure.
Check seat adjusters for proper operation.
n. Motor Relay (Four-Way, Tilt)
Removal and Installation
1. Remove front seat assembly from body and
place upside down on a clean protected surface.
2. Disconnect motor-to-motor r e l a y wire
harness.
3. Remove nut securing relay to support and
remove relay from seat assembly.
GEAR HOUSING DRIVING GEAR
GEAR
HARNESS SOLENOID
CONNECTOR PLUNGER
RUBBER COUPLER DOG SPRING DOG SHAFT
SOLENOIDS AND
COVER PLATE
SOLENOID
HOUSING
Fig. 16-68 Four-Way Seat Transmission