Cadillac 60 Series 1963 Shop Manual page 507

16-38
BODY
Weatherstrip Clip Reformer
;
Tool No. J-5984 i.
Clip
Fig. 16-44 Reforming Weatherstrip Clip
operation, the plug is still loose, install a second
piece of tape over the existing repair. This pro-
cedure can also be used to repair any waterleaks
that develop at sealing plug locations. A damaged
sealing plug must be replaced, Section C-C in
Fig. 16-42.
3. Clean off old cement from door to insure a
clean cementing surface. Apply a bead of an ap-
proved weatherstrip adhesive to lock pillar facing
of door and at lower front corner of door, shown
at A and B in Fig. 16-42. When applying weather-
strip adhesive to lock pillar facing of door, begin
application at belt line and continue down door for
approximately seven to nine inches. If necessary,
weatherstrip adhesive can also be applied to hinge
pillar facing of door.
4. Beginning at either front or rear section of
door, install snap fasteners. Install weatherstrip
attaching clips into their respective sealing plugs
by placing notched end of tool, J-5757, into loop
of wire clip and pushing clip into sealing plug,
Fig. 16-43.
NOTE: Do not distort weatherstrip attach-
ing clips or unsatisfactory weatherstrip reten-
tion will result.
All door weatherstrips are impregnated with a
silicone lubricant and additional lubrication is not
required.
39. Rear Door Lock Assembly
Removal and Installation
Locks are the rotary bolt type with the safety
interlock feature. With the safety interlock fea-
ture, it is very important that lock extension
engages properly in door lock striker notch and
that, where necessary, striker emergency spacers
of the proper thickness can be used to obtain
proper engagement.
1. Raise door window. Remove door trim as-
sembly and detach inner panel water deflector.
2. Through access hole, disengage spring clips
and detach inside lock connecting rod and remote
control connecting rod from lock assembly.
3. At lock pillar facing, remove door lock at-
taching screws and remove lock assembly through
access hole.
4. To install door lock, reverse removal pro-
cedure. Check all operations of door lock before
installing door trim and inside hardware.
40. Rear Door Vacuum Lock
Actuator Assembly
Removal and Installation
1. Remove door trim assembly and detach in-
ner panel water deflector.
2. Carefully disconnect vacuum hoses from
actuator assembly.
3. Due to relationship of actuator to lock as-
sembly, lock assembly must be removed to obtain
access to actuator attaching screws, Fig. 16-45.
4. Remove actuator from lock assembly as a
bench operation.
5. To install, reverse removal procedure.
Check all operations of locking system prior to
installing trim and inside hardware.
4 1 . Rear Door Lock to Locking
Lever Rod Removal and Installation
1. Raise door window, remove door trim pad
and detach inner panel water deflector sufficiently
to expose locking rod assembly.
2. Remove inside locking rod knob from rod.
Actuator Attaching Screws
Actuator Assembly
Rear Door
Lock
Assembly
Fig. 16-45 Rear Door Vacuum Actuator and Lock