Cadillac 60 Series 1963 Shop Manual page 580

BODY
16-111
SOLENOID IDENTIFICATION
1. REAR VERTICAL S O L E N O I D
2. HORIZONTAL SOLENOID
3. FRONT VERTICAL SOLENOID
CIRCUIT BREAKER
> y-j
•H
T-
TRANSMISSION & CLUTCH
CONTROL SOLENOIDS
RELAY
SEAT ADJUSTER
MOTOR
ARMATURE FEED - RED
GREEN
FIELD FEEDS
S I X - W A Y SEAT SWITCH TERMINAL BLOCK
No.
1
2
3
4
5
6
COLOR
RED
DARK BLUE
PINK
DARK GREEN
WHITE
YELLOW
FUNCTION
FEED
SOLENOID -HORIZONTAL MOVEMENT
FIELD FEED-REARWARD & D O W N
SOLENOID-REAR EDGE VERTICAL
SOLENOID - FRONT EDGE VERTICAL
FIELD FEED-FORWARD & U P W A R D
Fig. 16-138 Six-Way Seat Circuit - Switch In Seat. Side Panel
c. Checking Feed Circuit Continuity
at Relay on Seat Motor
1. Disengage 3-wire connector body from seat
motor relay terminal.
2. Insert one light tester lead into relay power
feed (red wire) connector slot on the harness,
and ground other light tester lead.
3. If tester does not light, there is no current
at end of feed wire. Failure is caused by an open
or short in feed circuit.
NOTE: In the following operations which
specify the seat control switch to be actuated,
a switch that has been checked for proper oper-
ation may be connected to the switch block. If
a switch is not available, a three-way jumper
wire can be made to perform the switch func-
tion. The jumper wire and the switch locations
to be connected to obtain a specific movement
of the seat are shown in Fig. 16-140. If a jump-
er wire is used, number the locations on the
switch block as indicated in the illustration.
Details outlining the making, and use of the
jumper wire are
following these checking procedures.
described under item " j "
d. Checking Seat Control Switch
1. Obtain switch or jumper wire and connect
to switch block.
2. Operate switch. If adjusters operate with
new switch or jumper wire, but did not operate
with original switch, the original switch is
defective.
3. Check all six movements of seat adjuster.