Cadillac 60 Series 1963 Shop Manual page 508

BODY
16-39
3. Disengage spring clip securing inside locking
rod assembly to door lock and disengage rod from
lock.
4. Disengage rod from spring clip on door inner
panel. Remove inside locking rod attaching bolt
and remove assembly from door, Fig. 16-46.
5. To install, reverse removal procedure.
Check operation of inside locking rod assembly
before installing water deflector and door trim
pad.
42. Rear Door Remote Control
Assembly and Connecting Rod
Removal and Installation
1. Raise door window. Remove door trim as-
sembly and detach inner panel water deflector
sufficiently to gain access to remote control
attaching bolts.
2. Remove remote control attaching bolts and
remove remote control from connecting rod,
Fig. 16-46.
3. Disengage remote control connecting rod
from lock and remove rod from door.
4. To install remote control and connecting
rod, reverse removal procedure. Position remote
control rearward sufficiently to take up slack in
linkage so that all clearances are taken out of
linkage in a rearward position. Check all oper-
ations of door lock before installing door inner
panel water deflector and trim pad.
43. Rear Door Inner Panel Cam
Removal and Installation
The inner panel cam is attached to the door
inner panel by two 7/16 inch attaching bolts and
is designed as a guide for the door window regu-
lator balance arm.
1. Raise door window, remove door trim pad
and detach inner panel water deflector sufficiently
to expose inner panel cam attaching bolts, Fig.
16-46.
2. Remove inner panel cam attaching bolts and
disengage cam from window regulator balance
arm roller and remove cam from door.
3. To install, reverse removal procedure. Prior
to installation of inner panel cam, lubricate entire
length of cam.
NOTE: Forward end of inner panel cam is
adjustable up or down. This adjustment can be
used to help correct a rotated or cocked door
window.
Inside Locking Rod
Attaching Bolt
SpringClip
Inner Panel Cam Attachinq Bolts
TRemote Control -
' Attaching Bolts j f f
Lower Sash Channel Cam Attaching Screws
Fig. 16-46 Rear Door Hardware
44. Rear Door Window Lower Sash
Channel Cam
Removal and Installation
1. Remove door trim pad and detach inner panel
water deflector.
2. Lower door window sufficiently to gain ac-
cess to sash channel cam two attaching screws,
through access holes in door inner panel, and
remove screws, Fig. 16-46.
3. While supporting window by hand, carefully
disengage cam from window lower sash channel
and rollers on window regulator arms and remove
cam from door.
CAUTION: After removal of lower sash
channel cam, carefully lower door window to
bottom of door to prevent damage to glass.
4. To install, reverse removal procedure. Prior
to installation, lubricate entire length of window
lower sash channel cam. Check operation of win-
dow prior to installing inner panel water deflector
and door trim pad.
45. Rear Door Window Guide Front
Cam and Rear Cam Assemblies
29, 39 and 89 Styles
a. Front Cam Assembly Removal and Installation
The window guide front cam assembly incorpo-
rates an attaching support bracket at upper edge
of the guide cam that is attached to the door hinge
pillar facing by two bolts. Front cam can be re-
moved without removing this attaching bracket.
1. Raise door window. Remove door trim as-
sembly and detach inner panel water deflector.