Cadillac 60 Series 1963 Shop Manual page 137

6-44
HYDRA-MATIC TRANSMISSION
Pry Bar S
s * '
m
• Apply
•iiiiliili
Ports
Neutral Clutch
...... . Apply Ports
Si,
S[
___j6il Pump "^
g£Attaching Screw
Fig. 6-75 Checking Center Bearing Support Alignment
bearing support in position. Opening in ring must
be at top of transmission case.
6. Rear clutch apply and neutral clutch apply
ports in case and in center bearing support must
be in alignment, Fig. 6-75. If not properly aligned,
center bearing support can be turned by tem-
porarily installing one oil pump attaching screw
and using a pry bar to turn support slightly.
7. Position reverse planet carrier on output
shaft, Fig. 6-76.
8. Install reverse stationary cone into case,
exercising care to prevent binding, Fig. 6-76.
9. Install tang type reverse carrier-to-internal
gear release spring, Fig. 6-76.
10. Install reverse internal gear on reverse
planet carrier. Rotate to align internal gear with
planet gears.
11. Install fiber thrust washer on reverse in-
ternal gear hub, Fig. 6-36.
12. Install screens in main line pressure pas-
sage and in G-2 passage.
13. Using new gasket, install reverse piston
housing assembly and attach with one screw,
Fig. 6-77.
14. Remove Clutch Retainer, J-6135, from in-
termediate shaft.
15. Install rear bearing over output shaft and
into piston housing.
16. Install snap rings retaining rear bearing
to output shaft and to reverse piston housing,
Fig. 6-77.
17. Install front (wave type) governor drive
gear snap ring.
Be certain snap ring is properly seated in
groove in output shaft.
18. Install governor drive gear key, Fig. 6-77.
19. Install governor drive gear, aligning slot in
gear with key, Fig. 6-77.
20. Install rear (flat type) governor drive gear
snap ring.
21. Install governor into reverse piston housing.
Be sure to compress oil seal rings as governor
assembly is installed.
22. Using new gasket, install extension housing
and breather pipe.
Drive Gear Snap Ring
Drive Gear Key
Governor Drive Gear
Drive Gear Key Slot
Rear Bearing Snap Rings
Fig. 6-76 Installing Reverse Internal Gear
Fig. 6-77 Installing Governor Drive Gear