Cadillac 60 Series 1963 Shop Manual page 139

6 -
HYDRA-MATIC TRANSMISSION
Fig. 6-80 Measuring T.V. Lever Clearance
4. Press inside detent control on manual shaft
as far as possible and tighten set screw securely.
5. Install O-ring seal on TV lever shaft and in-
stall TV shaft through manual shaft, Fig. 6-29.
Gage J-6282
Main Shaft
Selective Washer
Front Sun Gear
Spacer 861 6703
6. Install inner TV lever on TV shaft, aligning
serrations on shaft with serrations in lever. Tang
on inner TV lever points toward side of trans-
mission case, Fig. 6-80.
7. Press inner TV lever on TV shaft as far as
possible and then back off slightly to provide
.005 inch - .010 inch clearance between inner TV
lever and inside detent control, Fig. 6-80, and
tighten clamp screw.
8. Pull on outer TV lever to be sure inner TV
lever is secure on shaft. Recheck clearance and
adjust if necessary.
e. Install Control Valve and Servo-
Accumulator Assemblies
1. Position control valve assembly on trans-
mission case, aligning manual valve with pin in
inside detent control and inner TV lever with TV
plunger. Be sure dowel pin in manual body indexes
with hole in transmission case.
2. Install five control valve assembly attaching
screws and tighten, Fig. 6-27.
3. Install servo release spring and servo-
accumulator assembly and secure with two at-
taching screws. Make sure intake pipe clip is
under long bolt and leave this bolt loose until
intake pipe has been installed, Fig. 6-26.
f. Install Oil Pan, Oil Strainer and Intake Pipe
1. Install new O-rings in oil strainer and pipe
assembly if required.
2. Install intake pipe into strainer assembly,
being careful not to cut G-ring.
3. Install intake pipe into pump assembly, again
being careful not to cut O-ring.
4. Align strainer with retaining clip on coupling
valve body and press down to secure, Fig. 6-26.
5. Rotate pipe retaining clip over pipe and
tighten accumulator attaching screw.
6. Using new gasket, install oil pan. Torque
screws to 13 fo^ot-pounds.
7. Check oil pan drain plug tightness. Tighten
to 40 foot-pounds if necessary.
g. Install Front Unit Coupling Assembly
1. Install front unit coupling assembly into
case, making sure that unit engages both front
sprag and oil pump rotor.
Fig. 6-81 Checking Front Unit End Clearance
2. Perform front unit end play check as follows: