Cadillac 60 Series 1963 Shop Manual page 524

BODY
16-55
3. Move motor assembly towards left side of
seat sufficiently to disengage motor drive cable;
then, remove motor from support assembly. Mo-
tor drive cable may be removed, if required, by
removing cable end plate from transmission.
4. Install by replacing parts in reverse se-
quence, making sure motor drive cable is prop-
erly engaged at both motor and transmission.
f. Front Seat Adjuster Horizontal and Vertical
Drive Cables Removal and Installation
1. Remove front seat assembly from body with
attached adjusters, motor and transmission and
place upside down on a clean protected surface.
2. Detach both horizontal and vertical cables
from seat adjuster.
3. Remove screws securing horizontal and ver-
tical cable end plate on side of transmission from
which cables are being removed and remove ca-
bles from seat assembly, then disengage cables
from end plate.
4. To install horizontal and vertical cables,
reverse removal procedure. Make sure cables
are installed to correct gear nuts, Fig. 16-60.
g. Front Seat Adjuster Transmission
Removal and Installation
1. Remove front seat assembly from body with
attached adjusters, motor and transmission and
place upside down on a clean protected surface.
2. Disconnect wire harness connector from
transmission, Fig. 16-60.
3. Remove screws securing horizontal and ver-
tical cable end plate on both sides of transmission
and detach cables from transmission.
4. Remove transmission to support attaching
bolts; then disengage transmission from motor
drive cable and remove transmission from seat
assembly.
5. Install by replacing parts in reverse
sequence.
h. Front Seat Adjuster Transmission
Disassembly and Assembly
1. Remove front seat adjuster transmission
from seat assembly.
2. Remove screw securing ground strap to
solenoid housing and screws securing trans-
mission support to gear and solenoid housings.
3. Remove screws securing gear housing to
solenoid housing; then, carefully separate hous-
ings and remove component parts of transmission
assembly, Fig. 16-63.
SUPPORT PAD
SUPPORT
tea
SOLENOIDS &
COVER PLATE
HARNESS
CONNECTOR
DRIVING GEAR
THRUST WASHER -J
GEAR HOUSING
RUBBER
COUPLING
Fig. 16-63 Six-Way Seat Transmission - Disassembled