Cadillac 60 Series 1963 Shop Manual page 419

13-38
HEATING AND AIR CONDITIONING
Fig. 13-37 Removing Pulley Bearing Retainer Ring
Handle, J-8092, Fig. 13-39. The tool will apply
the force to the outer race of the bearing.
NOTE: Do not clean new bearing assembly
with any type of solvent. Bearing is supplied
with correct lubricant when assembled and
requires no other lubricant at any time.
6. Install bearing retainer ring, making certain
that it is properly seated in ring groove.
7. Install pulley and bearing assembly as des-
cribed in Note 33b.
8. Install clutch plate and hub assembly as
described in Note 32b.
Universal Handle
J-8092
Pulley Bearing
Remover J-9398
S u p p o r t
Block
J
-
9 5 2 1
Pulley and Bearing
Installer J-9481
Fig. 13-39 Installing Bearing in Pulley
35. Compressor Clutch Coil and Housing
Assembly Removal and Installation
The coil has 3.85 ohms resistance at 80° F
(ambient temperature) and should draw 3.2 amps
at 12 volts.
a. Removal
1. Remove clutch plate and hub assembly as
described in Note 32a.
2. Remove pulley and bearing assembly as
described in Note 33a.
3. Note position of terminals on coil housing
and scribe location on compressor front head
casting.
4. Remove coil housing retainer ring using
Snap Ring Pliers, J-6435 (#26) Fig. 13-40.
5. Lift coil
compressor.
b. Installation
and housing assembly off
Fig. 13-38 Removing Bearing From Pulley
1. Position coil and housing assembly on com-
pressor front head casting so electrical termi-
nals line up with marks previously scribed on
compressor.
2. Align locating extrusions on coil housing
with holes in front head casting.
3. Install coil housing retainer ring, with flat
side of ring facing coil, using Snap Ring Pliers,
J-6435 (#26).
4. Install pulley and bearing assembly as des-
cribed in Note 33b.