Cadillac 60 Series 1963 Shop Manual page 461

15-2
INSTRUMENT PANEL
Control selector unit with screwdriver in unit
mounting frame slots so upper cover can be
installed over selector wheel.
2. Connect 3-way wire connector for map light
and 3-way socket type connector for Guide-Matic
phototube unit, if car is so equipped.
3. Secure upper cover to lower panel with five
retaining screws, three screws above instrument
cluster, and two screws at inside top of glove box.
Push lower ends of vertical segments of top cover
in to e n g a g e fasteners at lower panel sub-
assembly.
NOTE: If car is equipped with Cruise Con-
trol, proceed with steps 4, 5, and 6; otherwise
omit.
4. Align Cruise Control selector unit with
screwdriver in unit mounting frame slots and
install escutcheon with two screws.
5. Install press fit "on" and "off" button.
6. Install left end cover to upper panel cover
with one screw.
7. Connect negative battery cable at battery.
2. Steering Column Lower Cover
Removal and Installation
a. Removal
1. Remove one special larger screw from upper
end of steering column lower cover.
2. Remove three screws from the upper end of
steering column lower cover.
NOTE: On convertibles, it will be necessary
to disconnect 3-way electric connector from
rear of convertible top control switch.
3. Remove five screws and washers from lower
end of steering column lower cover, and remove
cover.
4. Disconnect left hand cigar lighter jumper
wire 3-way connector.
b. Installation
1. Connect 3-way electric connector to rear of
convertible top control switch.
2. Connect left hand cigar lighter jumper wire
3-way connector.
3. Hold cover in position and loosely install one
screw and washer in lower left side of cover and
one screw and washer in lower right side
of cover.
4. Align cover and install one special larger
screw at upper end of cover.
5. Install three screws in upper end of cover
and tighten securely.
6. Install remaining three screws and washers
in lower end of cover. Tighten a l l five lower
cover screws securely.
3. Instrument Panel Bezel
Removal and Installation
a. Removal
1. Remove upper instrument panel cover as
described in Note la.
2. Remove steering column lower cover as
described in Note 2a.
3. Remove radio knobs, springs, and rings,
using an Allen wrench to remove screws.
4. Using Radio Control Knob Nut Wrench,
J-6968, remove retaining nuts on both control
shafts, Fig. 15-2.
5. Disconnect antenna lead-in cable and 4-way
electrical connector,at rear of radio.
6. Disconnect foot control unit from bottom of
A-M radio if so equipped.
7. Remove seven Phillips head screws at bot-
tom front of glove box and remove glove box
assembly.
8. Reaching through the glove box, remove
screw securing radio to rear support bracket.
Radio Control Knob Nut Wrench J-6968
Fig. 15-2 Removing Radio Control Knob Nut