Cadillac 60 Series 1963 Shop Manual page 500

BODY
16-31
for proper operation prior to installing inner
panel water deflector.
31. Front Door Ventilator Regulator-
Manual and Electric
a. Removal and Installation
1. Raise door window. Remove door trim as-
sembly and detach inner panel water deflector
sufficiently to gain access to regulator attaching
bolts.
2. On styles equipped with electric ventilator
regulators, disconnect regulator motor wires at
connector.
3. Remove ventilator tee shaft attaching bolt
and ventilator regulator attaching bolts, Fig.
16-35.
4. Disengage ventilator regulator shaft from
ventilator tee shaft and remove regulator and
motor assembly from door through access hole.
5. To install, reverse removal procedure.
Ventilator
to Door
Outer Panel
Return Flange
Attaching Screw
Vent Lower
Frame
Attaching Bolt
Vent "T" Shaft
Attaching Bolt
Vent Regulator
Attaching Bolts
Vent Lower
Frame Adjusting
Stud and Nut
Division Channel
Lower Adjusting
Fig. 16-35 Front Door Ventilator Attachments
Check operation of ventilator assembly prior to
installing inner panel water deflector.
b. Adjustments
1. Excessive "play" (flutter) of ventilator at
pivot shaft, when ventilator is in an open position,
can be corrected by tightening-ventilator tee shaft
to regulator attaching bolt, Fig. 16-35.
NOTE: Bolt should be tightened carefully
to avoid stripping threads in regulator spiral
gear shaft.
32. Front Door Ventilator Assembly-
Manual and Electric—
Except 23 and 33 Styles
a. Removal and Installation
1. Remove door trim assembly and detach in-
ner panel water deflector.
2. Lower door window. Remove ventilator to
door outer panel return flange attaching screw,
Fig. 16-35,
3. At front of ventilator assembly, break cement
bond securing front door hinge pillar sealing
strip (at belt) to ventilator assembly.
4. Remove ventilator division channel lower
adjusting stud and nut, Fig. 16-35.
5. On styles equipped with electrically operated
ventilator assemblies, disconnect motor and reg-
ulator assembly from ventilator frame and re-
move motor and regulator unit through large
access hole in door inner panel.
6. Remove ventilator lower frame attaching
bolt and ventilator lower frame adjusting stud nut,
Fig. 16-35.
7. Remove ventilator regulator.
8. Lift ventilator assembly upward and remove
from door.
9. Install by replacing parts in reverse se-
quence. Prior to installation of ventilator as-
sembly, apply a bead of body caulking compound
to door outer panel return flange along area con-
tacted by ventilator assembly.
b. Adjustments
The front door ventilator assembly can be ad-
justed up or down and in or out at the top and
forward section for alignment in the door opening
and proper weatherstrip contact in the ventilator
area. The lower portion of the ventilator division
channel can be adjusted in or out and fore and aft
for alignment with door window glass.