Cadillac 60 Series 1963 Shop Manual page 430

HEATING AND AIR CONDITIONING
13-49
Fig. 13-66 Installing O-Ring and Bushing
on Discharge Crossover Tube
Front
Discharge Valve
Plate Assembly
Dowel Pins
Support Block
J-9521
Fig. 13-68 Installing Front Discharge Valve
10. Using flat side of a small screwdriver,
gently press O-ring in around circumference of
internal mechanism until compressor shell slides
down over internal mechanism. As shell slides
down, line up oil sump with oil intake tube hole,
Fig. 13-72
11. Holding support block, invert assembly and
place in Holding Fixture with front end of shaft
down. Remove support block.
12. Install new dowel pins in rear cylinder half
if previously removed.
Front Suction
Reed Plate
Oil Return
Slot
Discharge
Crossover Tube
Support Block
J-9521
13. Install new O-ring in oil pick-up tube cavity.
14. Lubricate oil pick-up tube and install in
cavity, rotating compressor mechanism to align
tube with hole in shell baffle, Fig. 13-73.
15. Install new O-ring and bushing on rear of
discharge crossover tube.
16. Install rear suction reed over dowel pins
with slot toward sump.
17. Install rear discharge valve plate assembly
over dowel pins with reed retainers up.
18. Position inner oil pump gear over shaft
with previously applied identification mark up.
. * . : - . . . • .'- Recess
Rear Discharge
Valve Plate
H Bk-*——"""" S
uc
t'
on
w
Larger Dia.
Front Discharge
Valve Plate
Reed
Hole
\
Fig. 13-67 Installing Front Suction Reed
Fig. 13-69 Front and Rear Discharge Valve Plates