Cadillac 60 Series 1963 Shop Manual page 142

HYDRA-MATIC TRANSMISSION
6-49
Fig. 6-84 Installing Bushing in Flywheel
3. Tap Chisel with hammer until split in bush-
ing opens up, then remove bushing.
4. Install new bushing using Driver Head, J-
8400-2, and Handle, J-8092, Fig. 6-84.
c. Main Coupling Driven Torus—Fig. 6-85
1. Place driven torus on bench with bushing
side up.
2. Locate split in bushing and start point of
Chisel, J-8400-1, beside split with flat side of
Chisel facing in.
3. Tap Chisel with hammer until split in bush-
ing opens up, then remove bushing.
4. Install new bushing using Driver Head, J-
8400-4 and Handle, J-8092.
d. Front Unit Internal Gear, Fig. 6-86
1. Place Support, J-8400-30, on bench with
f t
*»
f V
> f *
! / 1
1
i,
J-8092
J-8400-6
J-8400-30
Large End Up
Fig. 6-86 Installing Bushing in Front
Unit Internal Gear
large end up, and position internal gear on Sup-
port with gear teeth up.
2. Locate split in bushing and start point of
Chisel, J-8400-1, beside split with flat side of
Chisel facing in.
3. Tap Chisel with hammer until split in bush-
ing opens up, then remove bushing.
Fig. 6-85 Installing Bushing in Driven Torus Hub
Fig. 6-87 Installing Bushing in Front
Coupling Driven Torus Shaft