Cadillac 60 Series 1963 Shop Manual page 115

6-22
HYDRA-MATIC TRANSMISSION
Outer TV
Lever
"O" Ring
Detent Spring
And Roller
Assembly
Detent Spring
Attaching Screw
Parking
Brake
Bracket
Pawl And p
a w
|
Lever p j
n
Assembly
Pawl Spacer
Inner TV Lever
Screws—"•'"
Fig. 6-29 Control Levers and Parking Brake Assemblies - Disassembled
15a), front unit coupling assembly (Note 15b),
oil pan, oil screen and intake pipe (Note 15c),
and control valve and servo-accumulator (Note
15d).
1. Remove pressure regulator plug assembly
from side of transmission, Fig. 6-32.
2. Remove pressure regulator spring and valve.
3. Remove three washer-head screws attaching
oil pump to center bearing support and remove
pump assembly, taking care to prevent pump
I
Detent Spring
And Roller Assembly
Parking Brake Bracket
/
f B i l l t L * / Parking Brake Spring
S^^fe
n9BrakeLever
" P°
w
l Spacer §HIMBBN* ^ # J o ^ ^
! | |
%ti|-Parking Brake Pawl / /
1
^
w
*
v
*-«^'--"
i
^ ^ j j ^ u ' Pawl Pivot Pin
cocking in bore. If pump assembly is tight in its
bore, it may be necessary to remove two nearly
opposite pump cover screws and install Slide
Hammer, J-6125, to remove pump, Fig. 6-33.
4. Remove pump locating screw and washer
from interior of transmission, Fig. 6-31.
5. Remove special tools from pump, if used.
6. Remove overrun clutch plate, release spring,
and bronze thrust washer if they did not come
out with pump.
h. Remove Center Bearing Support, Neutral
Clutch and Rear Unit Assembly
NOTE: Transmission must be removed from
Fig. 6-30 Removing Parking Pawl Pivot Pin
Fig. 6-31 Removing O i l Pump Locating Screw