Cadillac 60 Series 1963 Shop Manual page 545

16-76
BODY
A B C D E F G H I J
M
DOOR WINDOW REVEAL MOLDING (AT VENT)
WINDSHIELD PILLAR FINISHING MOLDING
WINDSHIELD PILLAR DRIP MOLDING SCALP
ROOF PANEL FRONT MOLDING
ROOF PANEL SIDE FRONT MOLDING
ROOF DRIP MOLDING FRONT SCALP
ROOF DRIP MOLDING REAR SCALP
ROOF PANEL SIDE REAR MOLDING
I. REAR END SIDE BELT MOLDING
J. REAR END CENTER BELT MOLDING
K. DOOR WINDOW LOWER REVEAL MOLDING
L. DOOR OUTER PANEL LOWER MOLDING
M. REAR FENDER LOWER MOLDING
N. QUARTER WINDOW LOWER REVEAL MOLDING
O. REAR COMPARTMENT LID OUTER PANEL MOLDING
P. REAR OF REAR FENDER LOWER MOLDING
Fig. 16-86 Exterior Moldings - 6357 Style
important to start the removal at a particular
location which is generally the "front" or "rear"
of the molding. This position is indicated when
necessary in the "Starting Location" column of
the molding chart.
85. Molding Clips
Removal and Installation
If it is necessary to replace a damaged "bath-
tub" molding clip, use the following procedure
for removal and installation:
The following groups of moldings are listed
with the name or description of the tool which is
suitable for molding removal:
Roof Drip Scalps - pointed hook tool
Door Window Scalps - thin flat-bladed tool such
as a putty knife
Snap-on Clips - thin flat-bladed tool such as a
putty knife
1. Insert sharp edge of flat-bladed tool, such
as a putty knife, under edge of clip and hammer
tool until base of clip is cut approximately half-
way through, Fig. 16-88, then disengage clip from
hole.
NOTE: In some cases, it may be necessary
to cut clip at opposite end of base also.
2. To install new clip, insert clip in hole in
outer panel and secure using Molding Retainer
Clip Installer, J--7160, Fig. 16-89.