Cadillac 60 Series 1963 Shop Manual page 259

10-24
FUEL AND EXHAUST
10. Secondary Throttle .020 inch - Gage No. 8
Lockout
b. Idle Speed-Up Control Removal
(On Cars Equipped with Air Conditioner)
1. Remove vacuum hose from idle speed-up
control.
2. Remove two mounting plate to bowl cover
screws and lock washers and remove idle speed-
up control, Fig. 10-33.
c. Bowl Cover Removal
1. Remove fuel inlet fitting, gasket and screen.
2. Disconnect choke connector rod at choke
shaft lever by removing hairpin clip, Fig. 10-34.
3. Disconnect throttle connector rod at pump
arm by removing hairpin clip, Fig. 10-35.
4. Remove fast idle connector rod by removing
screw from front end of choke shaft.
5. Remove fast idle connector rod from fast
idle cam.
6. Remove attaching screws with washers and
remove power piston cover plates, Fig. 10-36.
Hold cover plates against pressure when removing
screws.
Power Piston
Metering Ro
Power Piston Sprin
Cover Screw
And Lock Washer
^i i ^ Screw
Outer Choke yS
Shaft Lever %f Washer
r
> . w j f
P u m
P
A r m
Inner Choke
Shaft Lever
Clip
Throttle
Connector
Rod
Clip
Fast Idle
Connector
Rod
Clip
Pump Connector
Screws And Washers
Power Piston Cover Plate
Metering Rod Retaining Springs
Power Piston
Metering Rod
Power Piston Spring
Cover Screw And Lock Washer
Cover Screw And Lock Washer
Choke Valve Screws
Choke Valve
Bowl Cover
Choke Shaft
Choke Connector Rod
Gasket
Gasket
Float Needle Seat
Needle
Float
Accelerator Pump Assembly
Needle
Fuel Inlet Fitting
Bowl Cover Gasket
Gasket
Float Needle Seat
Float
Clip
Fig. 10-35 Bowl Cover Disassembled