Exterior Moldings - Cadillac 60 Series 1963 Shop Manual

16-74
BODY
EXTERIOR MOLDINGS
In this section, the methods of attachment of the exterior moldings to the
body are provided in a handy reference chart. In addition, illustrations
identifying the various exterior moldings on several body styles are shown.
84. Exterior Moldings
The exterior moldings are identified in Figs.
16-84, 16-85 and 16-86. The moldings are secured
to the body by any one or a combination of the
following attachments:
a. Attaching screws
b. Bolt and clip assemblies with attaching nuts
c. Integral studs with attaching nuts
d. Bath-tub type snap-on clips
e. Snap-in studs to pre-installed retainers
f. Snap-in clips
Typical attachments for body side moldings and
cross sectional views for some scalp and reveal
moldings are illustrated in Fig. 16-87.
Before using the body exterior molding chart
in this section, the following information will be
helpful when installing or removing exterior
moldings.
1. Screw locations - the exact location for each
screw is not shown or mentioned, but when hidden,
the general location is indicated by naming the
molding or other part which conceals the screw
and therefore must be removed to gain access to
the screw.
A. FRONT DOOR W I N D O W REVEAL MOLDING (AT VENT)
B. WINDSHIELD PILLAR DRIP MOLDING SCALP
C. FRONT DOOR W I N D O W REVEAL MOLDING
D. REAR DOOR W I N D O W REVEAL MOLDING
E. ROOF DRIP MOLDING FRONT SCALP
F. ROOF DRIP MOLDING REAR SCALP
G. ROOF EXTENSION PANEL LOUVERS
H. QUARTER BELT REVEAL MOLDING
I. FRONT DOOR OUTER PANEL LOWER MOLDING
J. REAR DOOR OUTER PANEL LOWER MOLDING
K. REAR OF REAR WHEEL OPENING MOLDING
L REAR OF REAR FENDER OUTER MOLDING (AT TAIL LAMP)
M. REAR OF REAR FENDER INNER MOLDING (AT TAIL LAMP)
N. REAR COMPARTMENT LID OUTER PANEL MOLDING
O. REAR OF REAR FENDER LOWER MOLDING
F i g . 1 6 - 8 4 Exterior Moldings - 6039 Style