Cadillac 60 Series 1963 Shop Manual page 504

BODY
16-35
incorporates an integral door check and hold-
open.
A view typical of a hardtop sedan 39 style rear
door, with trim assembly and inner panel water
deflector removed, is shown in Fig. 16-37. Fig.
16-38 is a view typical of a hardtop sedan 29 style
rear door. These illustrations identify component
parts of the rear door assembly, their relation-
ship and various attaching points.
a. Removal
Door and hinges can be removed as an assembly
from the center pillar or the door can be removed
from hinge straps.
1. On 29, 39 and 89 styles, lower door window.
2. Clean off excess sealer around each hinge
strap and mark location on door hinge pillar or
center pillar, depending on method of removal
being used.
3. On bodies equipped with electrically powered
window regulators, proceed as follows:
a. Remove door trim assembly and detach inner
panel water deflector sufficiently to gain access
to wire connector at motor.
b. Detach wire harness from door inner panel
and disconnect regulator motor from harness at
connector.
Fig. 16-38 Rear Door Assembly - 29 Styles
A.
B.
c.
D.
E.
F.
G.
H.
Rear Door
Rear Door
Plate
Rear Door
Cam
Rear Door
Plate
Rear Door
Rear Door
Rear Door
Rear Door
Window
Window
Window
Window
Outside
Lock to
Assembly
Front Female Wedge
Lower Sash Channel
Rear Female Wedge
Handle Assembly
Locking Lever Rod
Lock Assembly
Lock Remote Control to Lock
Rod Assembly
I.
J.
K.
L.
M.
N.
0 .
Rear Door Window
Assembly
Rear Guide Cam
Rear Door Lock Remote Control Assembly
Rear Door Window
Assembly
Rear Door Window
Motor Assembly
Rear Door Window
Manual
Guide Front Cam
Electric Regulator and
Regulator Assembly -
Rear Door Inside Locking Rod
Rear Door Window
Assembly
Inner Panel Cam