Cadillac 60 Series 1963 Shop Manual page 521

16-52
BODY
nut, forward until it disengages from upper slide
assembly. The four plastic shoes may now be
disengaged from positioning slots on lower track.
4. Install by replacing parts in reverse se-
quence, making sure groove in plastic shoe slips
onto lower track with thinner section of shoe pro-
truding above surface of track.
e. Front Seat Adjuster Actuator Motor
Removal and Installation
1. Remove front seat assembly as previously
described.
2. Disconnect both power drive cables from
actuator motor.
3. Remove two bolts that secure actuator motor
support bracket to weld nuts at front of seat bot-
tom frame and remove actuator motor with at-
tached support bracket from seat assembly.
4. When installing new motor, disconnect
motor-to-support bracket jumper ground wire
from motor and transfer support bracket with
inserted rubber grommets and attached jumper
ground wire from old motor to new actuator
motor.
5. Install by replacing parts in reverse se-
quence, and check seat operation to extreme limit
of fore and aft travel.
64. Front Seat Assembly
(Six-Way Electric)
The electrically-operated six-way front seat
assembly can be moved forward, rearward, up-
ward, downward or tilted by means of a
manually-operated seat control switch. The large
center control knob controls movement of the
entire seat assembly horizontally. The smaller
forward control knob controls vertical move-
ments of the front of the seat assembly causing
the seat assembly to "tilt". In the same manner,
the rear control knob controls vertical movement
of the rear of the seat assembly. To obtain maxi-
mum vertical travel, it will be necessary to en-
gage the center vertical control until the limit of
travel is reached, then engage the smaller for-
ward or rear control knob to complete the maxi-
mum travel. This is necessary due to removal of
the slip clutches in the seat transmission. This
seat adjuster operating mechanism incorporates
a transmission assembly which includes three
solenoids and six drive cables leading to the seat
adjusters.
# 1 - R E A R VERTICAL SOLENOID
#2-HORIZONTAL SOLENOID
# 3 - F R O N T VERTICAL SOLENOID
HORIZONTAL CONTROL
CABLE-BLACK
TRANSMISSION & SOLENOID
ASSEMBLY
REAR VERTICAL
CONTROL CABLE-BLUE
SEAT HARNESS
FEED CONNECTOR
REAR VERTICAL
CONTROL CABLE-BLUE
SEAT CONTROL
SWITCH
HORIZONTAL CONTROL
CABLE-BLACK
FRONT VERTICAL
CONTROL CABLE-YELLOW
FRONT VERTICAL
/CONTROL CABLE-YELLOW
SEAT MOTOR
MOTOR DRIVE CABLE
HARNESS TO MOTOR
RELAY CONNECTOR
TRANSMISSION END PLATE
HARNESS TO TRANSMISSION CONNECTOR
DARK GREEN-REAR EDGE VERTICAL CYCLE
WHITE-FRONT EDGE VERTICAL CYCLE
DARK BLUE-HORIZONTAL CYCLE
Fig. 16-60 Six-Way Seat Installation