Cadillac 60 Series 1963 Shop Manual page 577

16-108
BODY
SEAT GROUND WIRE
HORIZONTAL CABLE
- BLACK
MOTOR CONTROL RELAY
VERTICAL CABLE
- YELLOW
DRIVE CABLE &
RUBBER COUPLER
SEAT HARNESS
FEED CONNECTOR
TRANSMISSION
ASSEMBLY
HARNESS CONNECTOR
Fig. 16-136 Four-Way Bucket Seat Wiring Diagram
IMPORTANT: To obtain a seat movement
using a three-way jumper wire at switch block,
the switch feed location, one of the motor field
wire locations and one of the solenoid locations
have to be connected simultaneously.
The switch locations to be connected to obtain
a specific seat movement are outlined as follows:
1 5 2
3 4
LOCATION
1
2
3
4
5
JOIN ONE END
AS SHOWN ^
WIRE COLOR
RED
YELLOW
DARK BLUE
PINK
DARK GREEN
12 G A U G E
\ JUMPER WIRE
FUNCTION
SWITCH FEED
FIELD FEED-REARWARD & UP CYCLE
SOLENOID-HORIZONTAL MOVEMENT
FIELD FEED-FORWARD & DOWN CYCLE
SOLENOID-VERTICAL MOVEMENT
Fig. 16-137 Four-Way Seat Switch Block
(1) To raise seat, place jumper wire in loca-
tions 1, 2 and 5.
(2) To lower seat, place jumper wire in loca-
tions 1, 4 and 5.
(3) To operate seat forward, place jumper wire
in locations 1, 3 and 4.
(4) To operate seat rearward, place jumper
wire in locations 1, 2 and 3.
5. Checking Wires Between Control Switch and
Motor Relay
a. Disengage three - wire harness connector
from relay at motor.
b. Insert one light tester lead into motor field
connector slot on harness and ground other lead.
c. Actuate seat switch to energize field wire
being tested.
d. If tester does not light, there is no current
at end of wire. Failure is caused by an open or
short circuit between end of wire and switch.
Check other motor field wire in same manner.