Cadillac 60 Series 1963 Shop Manual page 200

ENGINE MECHANICAL
9-7
Fig. 9-6 Harmonic Balancer Assembly Removal
18. Remove pilot from end of crankshaft and
remove Harmonic Balancer Puller Tool from
harmonic balancer.
19. Disconnect heater inlet hose at cylinder
head water outlet pipe and heater outlet hose at
water pump.
20. Remove three cap screws that hold oil
filter assembly to oil filter support bracket and
remove filter assembly. Discard gasket.
21. Remove three remaining cap screws that
hold cylinder head water outlet pipe to cylinder'
heads and remove outlet pipe. Discard flange
gaskets and O-ring from neck of outlet pipe.
NOTE: On cars equipped with Air Condi-
tioner, remove four cap screws that hold water
outlet pipe to cylinder heads.
22. Remove cap screw and washer that hold
fuel filter to bracket on oil filler tube.
23. Remove twelve cap screws that hold engine
front cover to cylinder block and remove cover
with water pump attached, Fig. 9-7. Discard
gasket.
b. Installation
1. Position new front cover gasket over locat-
ing dowels on cylinder block.
NOTE: Apply a small amount of gasket
cement to hold gasket in place.
2. Install front cover, with water pump at-
tached, over end of crankshaft, lining up dowel
holes in cover with locating dowels on cylinder
block. Secure with twelve attaching screws. Refer
to Fig. 9-7 for proper screw location and torque
specifications.
3. Lubricate new water outlet pipe to water
pump O-ring seal with silicone, and install O-ring
against shoulder in bore, in pump body.
4. Brush gasket cement on water outlet pipe
flange surfaces and place new gaskets in position
on water outlet pipe.
5. Install neck of water outlet pipe in bore in
pump body, position flange surfaces against cylin-
der heads and install three (of the four) attaching
screws. Tighten screws to 20 foot-pounds. Do
not install screw that holds generator support
bracket at this time.
NOTE: On cars equipped with Air Condi-
tioner, install all four attaching cap screws.
6. Install oil filter assembly on oil filter sup-
port bracket, using new gasket, and secure with
three attaching screws. Tighten screws to 15
foot-pounds.
CAUTION: Before installing filter assembly,
fill oil passages in filter support bracket with
engine oil. This will allow oil pump to prime
itself when engine is started.
7. Install generator support bracket on water
outlet pipe and secure with two attaching screws.
Tighten screws to 20 foot-pounds.
8. Secure fuel filter to bracket on oil filler
tube with attaching screw and washer.
9. Connect heater inlet hose to water outlet
pipe and heater outlet hose to water pump.
Key
A
B
C
D
E
F
Size
5/16-18x3-1/4
3/8-16x3-5/8
3/8-16x3-7/8
5/16-18x2-1/8
5/16-18x2-1/2
5/16-18x1
Torque
10 foot-pounds
15 foot-pounds
15 foot-pounds
10 foot-pounds
10 foot-pounds
10 foot-pounds
Fig. 9-7 Engine Front Cover Attaching Screws