Cadillac 60 Series 1963 Shop Manual page 517

16-48
BODY
Arm Rest Cover
Rest
VIEW-C
57-67 Styles
29-39 Styles
Attaching Screw
Handle and Lamp
Assembly
•Door Inner Panel \
SECTION A-A % /-Attaching Screw
Fig. 16-55 Pull Handle and Arm Rest Assembly
3. To install, position retaining spring on handle
and bearing plate over regulator spindle. Position
handle on spindle at same angle as handle on op-
posite door and push handle until spring is
engaged.
NOTE: Handles are installed in a horizontal
position with open end forward when glass is in
a full up position.
58. Front and Rear Door Arm Rest
Assembly-6039, 6267, 6329,
6339, 6357, and 6367 Styles
The arm rest is attached to the door trim pad
on these styles and is not normally removed for
service operations.
a. Arm Rest Removal and Installation
1. Remove door pull handle or pull handle and
lamp assembly attaching screws.
2. Remove arm rest cover plate; see"b" below.
3. Where applicable, remove switch plate and
mounting base.
4. Remove door inside handles and door trim
pad.
5. Remove arm rest screw and washer assem-
blies and remove arm rest from door trim pad.
This should be done as a bench operation.
6. To install, reverse removal procedure.
b. Arm Rest Cover Plate Assembly—
6039, 6267, 6329, 6339, 6357 and 6367
Styles—Removal and Installation
1. Remove screws securing plate to arm rest
and remove cover plate, shown at C in Fig. 16-55.
2. To install, reverse, removal procedure.
59. Front and Rear Door Trim Assemblies
Removal and Installation
All door trim assemblies are the hang-on type
and are further secured by attaching screws along
bottom edge and by retaining nails inserted into
plastic retaining cups in door inner panel.
1. Remove door inside hardware, locking rod
knob and arm rest assembly.