Cadillac 60 Series 1963 Shop Manual page 112

HYDRA-MATIC TRANSMISSION
6-19
15. Transmission Disassembly to
Remove Major Components
a. Remove Flywheel, Torus Member, Torus
Cover and Flywheel Housing, Fig. 6-20
Fluid coupling cannot be removed as a unit.
Components must be taken off one at a time as
described below:
1. Remove eight attaching nuts and remove
flywheel from torus cover.
2. Remove flywheel to torus cover rubber oil
ring seal and discard.
3. Remove snap ring that retains driven torus
member to mainshaft, using Pliers, J-4880, and
remove driven torus member, Fig. 6-21.
4. Remove inner snap ring locating driven
torus member on mainshaft, using Pliers, J-4880,
Fig. 6-22.
5. Remove snap ring that retains driving torus
member to intermediate shaft, using Pliers,
J-6083, and remove driving torus member.
CAUTION: Do not attempt to remove torus
cover and driving torus member together.
6. Remove bronze thrust washer and steel se-
lective washer from front unit sun gear.
7. Remove front unit sun gear from shaft of
front unit coupling driven torus member.
8. Remove intermediate shaft snap ring, using
Pliers, J-8059.
,;. Driven Torus Assembly .
O M a i n Shaft Outer Snap Ring,
Cotter Pin Retaining
Torus Check Valve'
• , and Spring
Fig. 6-22 Removing Driving Torus Snap Ring
9. Remove internal gear with steel thrust
washer, needle bearing and second steel (black)
washer.
10. Remove torus cover.
CAUTION: Do not attempt to remove torus
cover by pulling or pushing on cover in a rough
manner, as this may result in a damaged oil
seal. Work hub of torus cover back through
oil seal and pull cover out with a quick motion.
11. Install Flywheel Housing Oil Seal Protector,
J-6119, remove six cap screws, and remove fly-
wheel housing, Fig. 6-23. Remove special tool.
Fig. 6-21 Remove Snap Ring Retaining
Driven Torus Member
Flywheel Housing
Oil Seal and Bushing
Protector J-6119
Fig. 6-23 Removing Flywheel Housing