Cadillac 60 Series 1963 Shop Manual page 109

6-16
HYDRA-MATIC TRANSMISSION
Oil Seal Installer
And Staker J-7026
Fig. 6-17 Installing Flywheel Housing O i l Seal
12. Flywheel Housing Oil Seal
Replacement
1. Remove transmission from car as described
in Note 13.
2. Remove flywheel housing from the trans-
mission as described in Note 15a.
Seal Installer over hub of flywheel housing with
seal centered in hub opening.
NOTE: Make certain that staking tool is not
in passage in side of Seal Installer while seal is
being installed.
7. Drive seal in with hammer, making certain
that seal is firmly seated on bottom of seal bore,
Fig. 6-17.
8. Insert staking tool into side of Seal Installer
and tap end of tool to stake edge of flywheel hous-
ing seal, Fig. 6-18. Seal should be staked into
position at three points, approximately 120° apart,
where housing has metal added.
NOTE: Do not strike staking tool with ham-
mer any harder than is necessary to stake edge
of seal lightly.
9. Install flywheel housing as described in
Note 18h.
10. Install transmission as described in
Note 14.
13. Removal of Transmission from Car
3. Drive old seal out of bore.
4. Using a file, carefully clean staked material
out of bore.
5. Place Flywheel Housing Support, J-7027, on
level area and position flywheel housing on
support.
6. Slide new seal on pilot of Flywheel Housing
Oil Seal Installer and Staker, J-7026, and position
1. Disconnect: battery.
2. Place car on hoist or on jack stands.
3. Remove starter motor and slush deflector.
4. Remove front and lower flywheel housing
covers.
5. Drain transmission at oil pan and torus
cover.
Oil Seal Installer
And Staker J-7026
Fig. 6-18 Staking Flywheel Housing O i l Seal
6. Remove transmission filler pipe bracket
bolt from exhaust manifold.
7. Clean dirt away from pipe flange and slide
filler pipe out of sleeve in transmission case.
8. Disconnect brake cables from parking brake
relay lever. Remove retracting spring and remove
relay from frame.
9. Remove propeller shaft assembly. See Sec-
tion 7, Note 10.
a. Loosen and remove nuts securing the two
engine side supports to the flywheel housing and
remove side supports from frame cross member.
10. Remove intermediate frame cross member
below flywheel housing.
•11. Disconnect speedometer cable from exten-
sion housing.