Cadillac 60 Series 1963 Shop Manual page 134

HYDRA-MATIC TRANSMISSION
6-41
5. Remove one screw retaining regulator body
to shift valve body and remove regulator body.
6. Remove neutral clutch spring, 2-3 TV regu-
lator valve spring, 2-3 shift valve spring, 3-4 TV
regulator valve spring, and 3-4 shift valve spring
from shift valve body.
7. Remove neutral clutch valve, 2-3 shift valve
with spacer, and 3-4 shift valve.
8. Remove four screws retaining shift valve
body end plate and remove plate.
9. Remove amplifier valve, 2-3 governor valve,
and 3-4 governor valve.
Shift valve body is completely disassembled, and
an inspection of parts should be made (see Note
17a) before valve body is assembled.
f. Shift Valve Body—Assembly
1. Install 3-4 governor valve with round end
facing outward.
2. Install 2-3 governor valve and amplifier
valve with largest lands facing outward, and attach
shift valve body end plate with four screws.
3. Install neutral clutch valve, and 3-4 shift
valve with largest diameter land facing outward.
4. Place spacer on large end of 2-3 shift valve,
with rim of spacer against large land on valve,
and install valve and spacer in shift valve body.
5. Install 2-3 and 3-4 shift valve springs and
neutral clutch valve spring.
6. Install regulator valve body to shift valve
body with one screw in boss on regulator valve
body. Use middle length screw.
7. Install 2-3 and 3-4 TV regulator valve
springs in regulator valve body.
8. Install 2-3 and 3-4 TV valves, with small
ends toward shift valves.
9. Install regulator valve body end plate with
two remaining screws.
Regulator Valve Body Cover
Regulator Valve
Body Plate
Neutral Clutch Valve Spring
Space
Neutral Clutch Valve
By-Pass
Reed Valve
3-4 TV
Regulator Valve
Regulator Valve Body
Amplifier Valve
'fk
2-3 TV Regulator
Valve Spring
Shifr Valve Body
3-4 TV Regulator
Valve Spring
3-4 Shift-Valve Spring
2-3 Shift Valve Spring
-4 Shift Valve
2-3 Shift Valve
'3-4 Governor Valve
2-3 Governor Valve
Shift Valve Body Plate
Fig. 6-70 Shift Valve Body - Disassembled