Cadillac 60 Series 1963 Shop Manual page 116

HYDRA-MATIC TRANSMISSION
6-23
Pressure
Regulator
Assembly
Plug Valve Stop Spring Valve
Pin
.L
"O" Ring Seal Reverse Booster Plug
i
Intermediate Shaft
Fig. 6-32 Removing Pressure Regulator Assembly
car. Requires removal of flywheel, torus mem-
bers, torus cover and flywheel housing (Note
15a), front unit coupling (Note 15b), oil pan,
oil screen and intake pipe (Note 15c), control
valve and servo-accumulator (Note 15d), and
oil pump and overrun clutch (Note 15g).
1. Install Neutral Clutch Retainer, J-6135, over
intermediate shaft and tighten screw, Fig. 6-34.
CAUTION: Locking screw must be positioned
toward front of transmission and screw must
be withdrawn far enough so as not to score
intermediate shaft during installation.
2. Remove eight cap screws and remove breath-
er pipe and extension housing and gasket. If hous-
ing sticks, a light tapping will loosen housing.
Discard gasket.
Slide Hammer
Assemblies
J-6125
Neutral Clutch
Retainer J-6135
inap Ring (Center Support to Case)
ISWUfc
Fig. 6-34 Removing Center Support to Case Snap Ring
3. Remove governor assembly from reverse
piston housing assembly by pulling rearward,
Fig. 6-35.
4. Remove gear (flat type) governor drive gear
retaining snap ring, governor drive gear, gover-
nor drive gear key and front (wave type) retaining
snap ring.
NOTE: Key may fall out when gear is re-
moved.
5. Remove rear bearing snap ring from output
shaft, Fig. 6-35.
Governor Drive Gear
Fig. 6-33 Removing O i l Pump Assembly
Fig. 6-35 Removing Governor Assembly