Cadillac 60 Series 1963 Shop Manual page 501

16-32
BODY
To adjust ventilator assembly, proceed as
follows:
1. Remove door trim assembly and detach in-
ner panel water deflector.
2. Remove ventilator frame to outer panel at-
taching screw.
3. Loosen ventilator lower frame attaching bolt.
4. Loosen ventilator division channel lower ad-
justing stud nut and ventilator lower frame adjust-
ing stud nut.
5a. To adjust ventilator assembly fore or aft
to windshield pillar side roof rail weatherstrip,
position lower frame adjusting stud and nut and
division channel stud and nut as required and
tighten attaching nuts.
b. To adjust ventilator assembly in or out, turn
adjusting studs on either lower frame, division
channel or both, as required, and tighten nuts.
c. After necessary adjustments have been per-
formed, tighten all nuts and bolts and replace
ventilator to door outer panel attaching screw.
NOTE: In some cases it may be necessary
to relocate ventilator to door outer panel return
flange attaching screw.
6. Seal water deflector to door inner panel and
install door trim and inside hardware.
33. Front Door Window Regulator
Assembly—Manual and Electric,
Except 23 and 33 Styles
a. Removal and Installation
1. Remove door trim assembly and detach in-
ner panel water deflector.
2. Remove ventilator division channel lower
adjusting stud and nut, Fig. 16-35.
3. On styles equipped with manual window reg-
ulators, lower window. Remove window lower
sash channel cam attaching screws and disengage
sash channel cam from window lower sash chan-
nel; then raise window and prop in full up position.
Disengage sash channel cam from window regu-
lator arm rollers.
4. On styles equipped with electric window
regulators, remove,door ventilator assembly and
front door window.
5. On styles equipped with electric window reg-
ulators, disconnect wire harness feed wires from
regulator motor at connector.
CAUTION: Do not operate regulator motor
after window assembly is disengaged from reg-
ulator. Operation of motor with load removed
may damage unit.
6. Remove window regulator attaching bolts.
Disengage regulator balance arm roller from
inner panel cam and carefully remove regulator
assembly from door, Fig. 16-34.
NOTE: On some models only one end of
inner panel cam is open sufficiently to permit
removal of regulator arm roller.
7. To install, reverse removal procedure.
Check window for proper operation prior to in-
stalling inner panel water deflector and door
trim pad.
b. Regulator Electric Motor Assembly
Removal and Installation
The electric motor assembly which powers the
window regulator on electrically operated win-
dows, is a twelve-volt, reversible direction motor
with a built-in circuit breaker and a self-locking
gear drive. The motor is secured to the regulator
assembly by screws.
1. Remove front door electric window regulator
assembly from door as described above and clamp
it. in a vise, Fig. 16-36.
NOTE:
vise will
sition of lift arm.
Position of regulator assembly in
vary with type of regulator and po-
CAUTION: Be sure to perform steps 2 and
3 before attempting to remove motor from
regulator. Regulator lift arm which is under
tension from counter-balance spring, can cause
serious injury if motor assembly is removed
without locking sector in position with a nut
and bolt.
Lift Arm Counter Balance Spring
A B
Fig. 16-36 Front Door Regulator Motor Removal