Cadillac 60 Series 1963 Shop Manual page 509

16-40
BODY
Front Guide Cam
Attaching Bolt
Rear Guide Cam
Upper Attaching Bolt
Male Wedge Plate
Attaching Bolts
Y Male Wedge Plate
\ Attaching Screws
Female Wedge Plate
Attaching Bolt
Rear Guide Cam
er Attaching Screw
EL
Regulator
Front Guide Cam LowerS Rear Guide Cam Lowerw*
Adjusting Stud and Nut Adjusting Stud and Nut
Fig. 16-47 Rear Door Window Guide Cam Removal
2. Through inner panel access hole remove
front guide cam upper attaching screw and front
guide cam lower adjusting stud and nut, Fig. 16-47.
3. Carefully disengage guide cam from window
lower sash channel roller and remove guide cam
through access hole.
4. To install, reverse removal procedure.
Prior to installation, lubricate entire length of
guide cam. Reseal front guide cam lower adjust-
ing stud and nut with body caulking compound.
5. Check operation of window assembly and,
where required, adjust window as described in
Note 47.
b. Front Cam Support Removal and Installation—
39 and 89 Styles
1. Remove door trim assembly and detach inner
panel water deflector.
2. Raise door window. Through inner panel
access hole remove front guide cam upper attach-
ing bolt, Fig. 16-47.
3. At door hinge pillar facing, remove two
screws securing guide cam support and remove
support through access hole.
4. To install, reverse removal procedure.
Check operation of window assembly and, where
required, adjust window as described in Note 47.
c. Rear Cam Assembly Removal and Installation—
29, 39 and 89 Styles
1. Raise door window. Remove door trim as-
sembly and detach inner panel water deflector.
2. Remove rear cam upper attaching screws
and lower adjusting stud and nut, Fig. 16-47.
3. Carefully disengage cam from roller on
window guide assembly and remove rear cam
through large access hole.
4. To install, reverse removal procedure.
Prior to installation, lubricate entire length of
cam. If exposed, seal cam lower adjusting stud
and nut with body caulking compound.
5. Check operation of window assembly and,
where required/adjust window as described in
Note 47.
46. Rear Door Window Regulator
Assembly—Manual and Electric
a. Removal and Installation
1. Lower door window. Remove door trim as-
sembly and detach inner panel water deflector.
2. Remove door window lower sash channel
cam. Then carefully raise window and prop in a
raised position.
3. On styles equipped with electric window
regulators, disconnect wiring harness feed wires
from regulator motor at connector.
4. On 29 and 39 styles, equipped with electric
window regulators, loosen rear guide cam upper
attaching screw and bolt and remove lower ad-
justing stud and nut to permit removal of electric
window regulator and motor assembly.
CAUTION: Do not operate regulator motor
after window assembly is disengaged from reg-
ulator. Operation of motor with load removed
may damage unit.
5. Remove regulator attaching bolts (four), dis-
engage balance arm from inner panel cam and
remove regulator assembly through large access
hole, Fig. 16-47.
6. To install, reverse removal procedure.
Check operation of window before installing inner
panel water deflector and rear door trim pad.
b. Regulator Electric Motor Assembly
Removal and Installation
The electric motor assembly which powers the
window regulator on electrically-operated win-
dows is a 12-volt reversible motor with a built-in