Cadillac 60 Series 1963 Shop Manual page 516

BODY
16-47
SECTION F-F
(PULL HANDLE)
SECTION G-G
(PULL HANDLE)
SECTION C-C
(ARM REST)
SECTION D-D
(SWITCH PLATE)
SECTION E-E
(SWITCH PLATE)
Fig. 16-54 Front and Rear Door Trim Assemblies
56. Front and Rear Door Pull
Handle and Lamp Assembly
a. Removal and Installation—
6039 and 6367 Styles
1. Remove two screws securing pull handle and
lamp assembly to door inner panel and remove
assembly from door.
2. To install, reverse removal procedure. It
may be necessary to seal pull handle attaching
screw holes with body caulking compound prior
to installation.
b. Removal and Installation—
6267, 6329, 39 and 57 Styles
1. Remove two screws securing pull handle and
lamp assembly to door inner panel, shown at B
and Section A-A in Fig. 16-55.
2. Remove trim pad and pull handle "pal" nuts.
3. To install, reverse removal procedure. It
may be necessary to seal pull handle and lamp
assembly attaching screw holes with body caulking
compound prior to installation.
57. Front and Rear Door Inside
Handles—Removal and Installation
A. On styles equipped with door inside remote
control "paddle" handles, proceed as follows:
1. Remove door arm rest.
2. On styles equipped with arm rest cover
plates, remove cover plates.
3. Remove handle-to-remote attaching bolt and
remove handle from door.
4. To install, reverse removal procedure.
B. On styles not equipped with "paddle" han-
dles and for removal of manually operated door
ventilator and window inside handles, proceed as
follows:
1. Depress door trim assembly at handle suffi-
ciently to install tool, J-7797, between handle and
bearing plate.
2. Push handle retaining spring out of engage-
ment and remove handle and bearing plate from
door.