Cadillac 60 Series 1963 Shop Manual page 513

16-44
BODY
NOTE: Bolt should be tightened carefully
to avoid stripping threads in regulator spiral
gear shaft.
49. Rear Door Ventilator Assembly—
6039 Styles
The rear door ventilator assembly on 6039
styles is very similar to most 29 or 39 style front
door v e n t i l a t o r assemblies and is always
power-operated.
a. Removal and Installation
1. Remove door trim assembly and detach inner
panel water deflector sufficiently to expose large
access hole in door inner panel.
2. Remove ventilator regulator assembly.
3. Lower door window. Remove ventilator to
door outer panel return flange attaching screw,
Fig. 16-50.
4. Remove ventilator division channel lower
adjusting stud and nut.
5. Remove ventilator adjusting stud and nut and
ventilator attaching bolts, Fig. 16-49.
6. Raise ventilator assembly and remove from
door.
7. To install, reverse removal procedure.
b. Adjustments
1. To adjust ventilator assembly in or out:
a. Remove door trim assembly and detach inner
panel water deflector sufficiently to expose venti-
lator assembly adjusting stud and nut, Fig. 16-50.
b. Loosen ventilator division channel lower ad-
justing stud and nut.
c. Loosen ventilator assembly adjusting nut and
adjust stud as required; and tighten nut.
d. Adjust lower division channel adjusting stud
as required, check window for proper operation
and alignment and tighten stud nut.
2. To adjust ventilator assembly fore or aft:
a. Remove door trim assembly and detach
upper portion of inner panel water deflector.
b. Loosen ventilator division channel lower ad-
justing stud and nut.
c. Loosen ventilator assembly adjusting stud
nut and ventilator attaching bolts.
d. Adjust window fore or aft as required, check
window for proper operation and alignment and
tighten adjusting stud nuts and ventilator attach-
ing bolts.
NOTE: If ventilator is to be adjusted for-
ward, the rear door window guide front cam
assembly must be loosened to permit window
assembly to be moved forward.
50. Front and Rear Door
Outside Handle Assembly
a. Removal and Installation
1. Raise door window. Remove door trim as-
sembly and detach upper rear corner of inner
panel water deflector sufficiently to gain access
to door outside handle attaching screws.
2. Remove screws and door lock handle and
gaskets from outside of body.
3. To install, reverse removal procedure.
b. Assembly and Disassembly of Door Outside
Handle Push Button
1. Remove door outside handle.
2. Depress retainer slightly and turn one quar-
ter (1/4) turn. Remove retainer, spring, push
button and shaft and sealing ring from handle.
3. To assemble, reverse disassembly proce-
dure, Fig. 16-51.
51. Front and Rear Door Lock Strikers
a. Removal and Installation
1. With a pencil, mark position of striker on
body pillar.
2. Remove three door lock striker attaching
screws and remove striker and adjusting plates
from pillar.
Screws
Outside | Push Button
Handle Washer , & Shaft Spring Retainer
Fig. 16-51 Door Outside Handle Disassembled