Cadillac 60 Series 1963 Shop Manual page 555

16-86
BODY
H / 2
Material Per Stick:
Wood—1/2" x 1" x 15-1/2" 2 Screws—#6 x 1/2"
Steel—1 /32" x 1 IT x 2-1 IT Bolt—11A x 20 x 1"
Steel—1/32" x 1-1/2" x 7" Wingnut—1/4—20
2 Washers—1/4" I.D.
Fig. 16-99 Spacer Stick Dimensions
21. Remove side stay pads. Stay pads are at-
tached to front roof rail and front and rear bows
with tacks; to center bow, and side roof front
rail with screws.
b. Installation
1. If new top is being installed but it was im-
possible to perform step 14 of removal procedure,
preset spacer sticks to shortest length and in-
stall between center and rear roof bow, Fig.
16-98. Adjust sticks so that dimension "X" in
Fig. 16-98 (measured along spacer stick from
front upper rolled edge of rear roof bow to center
of center bow) is 16-3/8" ± 1/4". Tie or tape rear
bow to rear side roof rails.
Fig. 16-100 Side Stay Pad Installation