Suzuki XL7 2007 Service Manual page 1398

4E-48 ABS:
Callout
Preliminary Procedures
1. Place the ignition switch in the OFF position.
2. Remove the underhood electrical center. Refer to "Underhood Electrical Center or Junction Block Replacement:
".
3. Clean the electronic brake control module (EBCM) to brake pressure modulator valve (BPMV) area of any dirt or
debris.
Electronic Brake Control Module (EBCM) Electrical Connector
1
Tip: Release the locking tab and rotate the electrical connector cover upward to release.
EBCM to Brake Pressure Modulator Valve (BPMV) Screw (Qty: 4)
CAUTION
!
Refer to "Fastener Notice: ".
2
Tightening torque
3 N⋅m (27 lb in)
Tip: Tighten the screws in a cross pattern.
3 Electronic Brake Control Module
EBCM to BPMV Seal (Qty: 12)
Tip:
• If installing a new EBCM, program the EBCM. Refer to "Control Module References: ".
• Without starting the engine, place the ignition switch in the ON position.
4
• Perform the "Diagnostic System Check - Vehicle Diagnostic Information: ".
• Observe the feel of the brake pedal after performing the diagnostic system check. If the pedal now
feels spongy, air may have been in the secondary circuit of the brake modulator assembly, which
may have been introduced into the primary circuit. If the pedal feels spongy, perform the "Antilock
Brake System Automated Bleed Procedure".
Electronic Brake Control Module Programming and Setup
EBCM Replacement
If the electronic brake control module (EBCM) is replaced, the following procedures must be performed:
EBCM Reprogramming—Refer to "Service Programming System (SPS): ".
EBCM Reprogramming
If the EBCM needs to be reprogrammed, refer to "Service Programming System (SPS): ".
Setup for Component Replacement
The replacement of ABS components such as the steering wheel position sensor may require a setup procedure for
complete repair. Refer to "Steering Angle Sensor Centering"
Component Name