Table of Contents
Advertisement
Brake Pressure Modulator Valve Replacement
Callout
WARNING
!
Refer to "Brake Fluid Irritant Caution: ".
CAUTION
!
Refer to "Brake Fluid Effects on Paint and Electrical Components Notice: ".
CAUTION
!
Always connect or disconnect the wiring harness connector from the EBCM/EBTCM with the ignition
switch in the OFF position. Failure to observe this precaution could result in damage to the EBCM/
EBTCM.
Preliminary Procedures
1. Place the ignition switch in the OFF position.
2. Clean the brake pipe fittings of any dirt or debris.
3. Remove the underhood electrical center. Refer to "Underhood Electrical Center or Junction Block Replacement:
".
4. Place a clean cloth under the brake modulator assembly to catch any brake fluid loss.
Electronic Brake Control Module (EBCM) Electrical Connector
1
Tip: Release the locking tab and rotate the electrical connector cover upward to release.
Component Name
ABS:
4E-49
Advertisement
Table of Contents
Troubleshooting
