Changing A Data Value; Infinitely Variable Change Of Numeric Data Value; Value, Step By Step; Readout And Programming Of Indexed Parameters - Danfoss VLT AutomationDrive FC 301 Programming Manual

How to Program

2.1.12 Changing a Data Value

If the selected parameter shows a numeric data value,
change the selected data value with the [
▲ ▼
keys and the [ ] [ ] navigation keys. Press [
move the cursor horizontally.
113 RPM
Load depen. setting
1 - 60 Low speed load
compensation
100%
Illustration 2.17 Changing a Data Value
▲ ▼
Press [ ] [ ] keys to change the data value. [
▼
the data value, and [ ] decreases the data value. Place the
cursor on the value to save and press [OK].
729RPM
Load depen. setting
1 - 60 Low speed load
compensation
6
1 0%
Illustration 2.18 Saving a Data Value
2.1.13 Infinitely Variable Change of
Numeric Data Value
If the selected parameter shows a numeric data value,
◀ ▶
select a digit with [ ] [ ].
635 RPM
Start Adjustments
1 - 71 Start Delay
00.0s
Illustration 2.19 Selecting a Digit
Change the selected digit infinitely variably with [
The cursor indicates the selected digit. Place the cursor on
the digit to save and press [OK].
MG33MO02
Programming Guide
◀ ▶
] [ ] navigation
◀ ▶
] [ ] keys to
1.78 A 1(1)
1- 6*
▲
] increases
6.21A 1(1)
1- 6*
0.44 A 1 (1)
1- 7*
▲ ▼
] [ ].
Danfoss A/S © 01/2018 All rights reserved.
957RPM
Start Adjustments
1-71 High starting torque time
0. s 4
Illustration 2.20 Saving

2.1.14 Value, Step by Step

Certain parameters can be changed step by step. This
applies to:
•
Parameter 1-20 Motor Power [kW].
•
Parameter 1-22 Motor Voltage.
•
Parameter 1-23 Motor Frequency.
The parameters are changed both as a group of numeric
data values and as numeric data values that are infinitely
varying.
2.1.15 Readout and Programming of
Indexed Parameters
Parameters are indexed when placed in a rolling stack.
Parameter 15-30 Fault Log: Error Code to
parameter 15-32 Alarm Log: Time contain a fault log, which
can be read out. Select a parameter, press [OK], and press
▲ ▼
the keys [ ] [ ] to scroll through the value log.
For example, parameter 3-10 Preset Reference is changed as
follows:
1. Select the parameter, press [OK], and press [
to scroll through the indexed values.
2. To change the parameter value, select the
indexed value and press [OK].
3.
Change the value by pressing [
4. Press [OK] to accept the new setting.
5. Press [Cancel] to abort. Press [Back] to leave the
parameter.
2.1.16 How to Program on the Numerical
Local Control Panel
The following instructions are valid for the numerical LCP
(LCP 101).
The control panel is divided into 4 functional groups:
•
Numerical display.
•
Menu keys and indicator lights - changing
parameters and switching between display
functions.
•
Navigation keys and indicator lights.
•
Operation keys and indicator lights.
11.58A 1 (1)
1-7*
2
▲ ▼
] [ ]
▲ ▼
] [ ].
19
2