Parameters: 9-** Profibus; Parameters: 10-** Devicenet Can Fieldbus; Parameters: 12-** Ethernet - Danfoss VLT AutomationDrive FC 301 Programming Manual

Parameter Descriptions
8-57 Profidrive OFF2 Select
Select control of the frequency converter OFF2 selection via the
terminals (digital input) and/or via the fieldbus. This parameter is
active only when parameter 8-01 Control Site is set to [0] Digital
and ctrl. word and parameter 8-10 Control Word Profile is set to [1]
3 3
PROFIdrive profile.
Option:
[0]
[1]
[2]
[3]
*
8-58 Profidrive OFF3 Select
Select control of the frequency converter OFF3 selection via the
terminals (digital input) and/or via the fieldbus. This parameter is
active only when parameter 8-01 Control Site is set to [0] Digital
and ctrl. word, and parameter 8-10 Control Word Profile is set to [1]
PROFIdrive profile.
Option:
[0]
[1]
[2]
[3]
*
3.9.6 8-8* FC Port Diagnostics
These parameters are used for monitoring the bus
communication via the frequency converter port.
8-80 Bus Message Count
Range:
0 [0 - 0 ] This parameter shows the number of valid
*
8-81 Bus Error Count
Array [6]
Range:
0 [0 - 0 ] This parameter shows the number of telegrams
*
8-82 Slave Messages Rcvd
Range:
0 [0 - 0 ] This parameter shows the number of valid
*
8-83 Slave Error Count
Range:
0 [0 - 0 ] This parameter shows the number of error
*
142
Function:
Digital input
Bus
Logic AND
Logic OR
Function:
Digital input
Bus
Logic AND
Logic OR
Function:
telegrams detected on the bus.
Function:
with faults (for example CRC fault) detected on the
bus.
Function:
telegrams addressed to the slave sent by the
frequency converter.
Function:
telegrams, which are not executed by the
frequency converter.
Danfoss A/S © 01/2018 All rights reserved.
®
VLT AutomationDrive FC 301/302
3.9.7 8-9* Bus Jog
8-90 Bus Jog 1 Speed
Range:
100 RPM
8-91 Bus Jog 2 Speed
Range:
200 RPM

3.10 Parameters: 9-** PROFIBUS

For PROFIBUS parameter descriptions, see the VLT
PROFIBUS DP MCA 101 Programming Guide.
3.11 Parameters: 10-** DeviceNet CAN
Fieldbus
For DeviceNet parameter descriptions, see the DeviceNet
Operating Instructions.

3.12 Parameters: 12-** Ethernet

For Ethernet parameter descriptions, see the VLT
EtherNet/IP MCA 121 Operating Instructions.
Function:
[ 0 - par. 4-13 Enter the jog speed. Activate this
*
RPM] fixed jog speed via the serial port
or fieldbus option.
Function:
[ 0 - par. 4-13 Enter the jog speed. Activate this
*
RPM] fixed jog speed via the serial port
or fieldbus option.
®
®
MG33MO02