Danfoss VLT AutomationDrive FC 301 Programming Manual page 165

Parameter Descriptions
13-52 SL Controller Action
Option: Function:
[27] Coast The frequency converter coasts
immediately. All stop commands including
the coast command stop the SLC.
[28] Freeze output Freezes the output frequency of the
frequency converter.
[29] Start timer 0 Starts timer 0, see parameter 13-20 SL
Controller Timer for further description.
[30] Start timer 1 Starts timer 1, see parameter 13-20 SL
Controller Timer for further description.
[31] Start timer 2 Starts timer 2, see parameter 13-20 SL
Controller Timer for further description.
[32] Set digital out Any output with smart logic output A is
A low low.
[33] Set digital out Any output with smart logic output B is
B low low.
[34] Set digital out Any output with smart logic output C is
C low low.
[35] Set digital out Any output with smart logic output D is
D low low.
[36] Set digital out Any output with smart logic output E is
E low low.
[37] Set digital out Any output with smart logic output F is
F low low.
[38] Set digital out Any output with smart logic output A is
A high high.
[39] Set digital out Any output with smart logic output B is
B high high.
[40] Set digital out Any output with smart logic output C is
C high high.
[41] Set digital out Any output with smart logic output D is
D high high.
[42] Set digital out Any output with smart logic output E is
E high high.
[43] Set digital out Any output with smart logic output F is
F high high.
[60] Reset Counter Resets counter A to 0.
A
[61] Reset Counter Resets counter B to 0.
B
[70] Start timer 3 Starts timer 3, see parameter 13-20 SL
Controller Timer for further description.
[71] Start timer 4 Starts timer 4, see parameter 13-20 SL
Controller Timer for further description.
[72] Start timer 5 Starts timer 5, see parameter 13-20 SL
Controller Timer for further description.
[73] Start timer 6 Starts timer 6, see parameter 13-20 SL
Controller Timer for further description.
MG33MO02
Programming Guide
13-52 SL Controller Action
Option:
[74] Start timer 7
[120] Start Homing
[121] Stop Homing
[122] Enable
Reference
[123] Disable
Reference
[124] Relative
Position
[125] Absolute
Position
[126] Activate
Touch
Danfoss A/S © 01/2018 All rights reserved.
Function:
Starts timer 7, see parameter 13-20 SL
Controller Timer for further description.
NOTICE
This option is available only with
software version 48.20 and newer.
Activates the homing mode and starts the
homing function selected in
parameter 17-80 Homing Function. Must
remain active until the homing is
completed otherwise the homing is
aborted.
NOTICE
This option is available only with
software version 48.20 and newer.
Deactivates the homing mode, an active
homing function is aborted if the homing
is not completed.
NOTICE
This option is available only with
software version 48.20 and newer.
Sets the enable reference mode.
NOTICE
This option is available only with
software version 48.20 and newer.
Disables the enable reference mode.
NOTICE
This option is available only with
software version 48.20 and newer.
Selects the relative position mode instead
of the absolute position mode.
NOTICE
This option is available only with
software version 48.20 and newer.
Selects the absolute position mode instead
of the relative position mode.
NOTICE
This option is available only with
software version 48.20 and newer.
Activates the touch probe positioning
mode.
3 3
163